资源列表
PI
- 该c程序采用keil c51编写，主要实现对直流电机调速，其中包含转速环PI调节器c代码-The c program using keil c51 prepared, the main achievement of the DC motor speed, including speed loop PI controller c code
BH1750FVC_DEF
- BH1750 测光强程序 用于测量光源的强度 0-65535流明-BH1750 metering program used to measure light intensity strength 0-65535 lumen
dsp-cap
- 该程序在DSP2407芯片上实现捕获中断，通过捕获中断计算出外部信号的频率。频率的数值通过数码管显示出来。是一个C语言工程文件，对dsp2000编程很有参考意义。-The program in the DSP2407 chip capture interrupt, interrupted by capturing external signals to calculate the frequency. Numerical frequency through digital tube displa
BH1750FVI_AVR
- BH1750FVI光强度测量芯片运行功能程序,适用于AVR程序烧录至单片机-digital ambient light intensity measurement device with high-precision, wide range, low cost with BH1750 FVI
M-busFORMSP430
- MSP430F149 M-BUS通信演示，带有PDF格式说明书。-MSP430F149 M-BUS communication demo, with the manual in PDF format.
ad
- 此程序为使用单片机，通过74hc595以及74hc138进行行列扫描，最终在LED上显示滚动的汉字。-This procedure for the use of SCM, and 74hc138 to the ranks by 74hc595 scan, eventually rolling LED display Chinese characters.
LED-control
- 有74HC595和三极管联合控制的8*8点LED显示屏的现实驱动电路设计图-74HC595 and the transistor have joint control of the 8* 8 LED display drive circuit design reality
340_i2c
- 新华龙C8051F340单片机I2C总线的程序 保证可以用-Hualong C8051F340 new single-chip I2C bus can be used to ensure that the procedures
ad5612
- 是对AD5612读写的C程序，我在STC单片机上运行，效果很好-good
UART
- PIC18f系列单片机采用UART模式的发送，字符串的发送-PIC18F series of microcontrollers in the sending of UART mode, the string to send
alu_74181
- 4 bit alu to replace a 74LS181
S3C2410
- 三星ARM9的中文手册，新手嵌入式入门开发板资料-Samsung ARM9 Chinese manual, novice embedded development board data entry