资源列表
uCOS-II_LINUX_3.2
- ucosii在linux下的porting-ucosii in porting under linux
lab23-SCIC
- 给予TMS320F28335的串口SCIC所编写的串口测试程序，可以实现简单的串口算法-SCIC give TMS320F28335 serial port test program written for simple serial algorithm
LCD
- 用vhdl语言编写的lcd液晶屏1602驱动程序，直接下载运行即可。-lcd
Freq
- 51单片机精确测量脉冲频率的程序，通过修改测量周期可以测量1Hz以下至500KHz的频率范围-51 single accurate measurement of pulse frequency of the program, by modifying the following measurement cycle can be measured 1Hz to 500KHz frequency range
lcd
- 低功耗温控器程序 PIC16F946 控制 带液晶驱动 10uA待机。-Low-power thermostat program PIC16F946 control with LCD driver 10uA standby.
Timer1_Sleep
- 单片机 pic16F73 休眠并自动重新启动的程序。在mplab的PICC中编译。-The program for mcu pic16f73 fall in sleep and wake up by timer.
M32.over.ENC28J60.webserver-V0.9
- 基于uip协议栈，开发的avr M32的websever-Uip-based protocol stack, the websever development avr M32
Series_CSTR
- 此程序是串联连续搅拌反应釜的仿真程序，模拟了CSTR的温度液位，及反应。-This program is a series of continuous stirred tank reactor simulation program to simulate the temperature of CSTR level, and response.
FreeModbus_uCOS
- 本程序基于STM32F103VET6，成功的将FreeModbus 和 uC/OSII 移植上去。Modbus（Rtu RS232 从机）。有问题请与我联系！QQ：383016632。-The program is based on STM32F103VET6, the success of the FreeModbus and uC/OSII transplantation up. Modbus (Rtu RS232 from the machine). There are problems
liushuideng
- 本程序是用VHDL编写的一个流水灯程序，虽然简单，但对于初学者一定很有帮助。-The program is written in a flowing light VHDL program, although simple, but certainly very helpful for beginners.
一个24c16的读写程序
- 一个24c16的读写程序，编译调试通过了的。单片机需要读IC卡的朋友注意了-24c16 a literacy program, compile pass the debugging. SCM need to read IC cards to a friend! !
ds18b20
- ds18b20数码管显示，可以显示到小数点后2位，含有protel原理图，经硬件测试可用-DS18B20 digital tube, it can be displayed to two decimal places, containing Protel schematic diagram, the test can be used by the hardware