资源列表
MT57
- 使用单片机细分57步进电机源程序，按64细分处理，定位准确，可用于舞台灯光电机细分驱动-57 stepper motor using microcontroller source breakdown, according to 64 segments processing, accurate positioning can be used for stage lighting drive motor breakdown
Stepper_Motor
- To interface Stepper Motor to PIC 18f4550 Targetboard : Aurum v1.1/1.2 the speed motor can be controlled or varied by changing delay
temp_lm35
- This program demonstrates the interfacing of LM35 temperature sensor IC to the microcontroller In this program the internal ADC, timer and interrupt modules are used as a part of the measurement. The measured value of the temperature is then dis
stm32-DHT11
- dht11温湿度传感器驱动程序，并且显示在lcd上，亲测可用-dht11 temperature and humidity sensor driver, and display on lcd, pro-test available
GPIO_ONE
- 用PIC12F509做的OTP MCU高尔夫球帽帽沿灯程序，MPLAB IDE v8.90环境下编译，接收一个按键切换四种不同工作模式。-OTP MCU PIC12F509 to do with golf hat brim lights, under MPLAB IDE v8.90 compiler environment, receiving a button to switch to four different operating modes.
DMX512_LCD
- 使用带21路PWM输出的STK MCU接收DMX512信号，并显示在不带字库LCD显示屏上，看用来测试DXM512信号接收或发送情况。-Use with 21 PWM outputs STK MCU receives DMX512 signal, and displayed on non-character LCD display, look to test DXM512 signal reception or transmission case.
LCD0880
- 电子烟用0.69LCD显示屏驱动源代码，C语言keil环境编写，可驱动96*16点阵显示屏显示。-请键入文字或网站地址，或者上传文档。 取消 Diànzǐ yān yòng 0.69LCD xiǎnshì píng qūdòng yuán dàimǎ,C yǔyán keil huánjìng biānxiě, kě qūdòng 96*16 diǎn zhèn xiǎnshì píng xiǎnshì.Electronic cigarette 0.69LCD display drive
TM1639
- 带按键数码管驱动芯片TM1639源代码，可用于家用电器显示或多个按键的数码显示用。-Digital with key LED Driver IC TM1639 source code can be used to display one or more keys appliances display.
STM32F103-DTH11
- 基于stm32f103处理器的温湿度传感器DHT-this case is based on the stm32f103 MCU to process temperature and humidity
www
- 一种红外编码解码的仿真，仿真软件为Proteus,没有硬件也可以学习红外编码解码知识-An infrared codec simulation, simulation software for the Proteus, no hardware codec can learn IR knowledge
IR
- Infrared codec c-language document, with detailed comments, we hope to be useful-Real-time curve display serial data received, VC programming, detailed documentation
rf
- 使用STK单片机控制2.4G无线发送与接收源代码，有参考价值-Use STK SCM 2.4G wireless transmitter and receiver source code, a reference value