资源列表
MSP430-driver-nokia5110
- CR_2005_Ver1（MSP430驱动nokia5110）微控器为msp430g2553 显示器nokia5110-CR_2005_Ver1 (MSP430 driver nokia5110)
Msp430-interrupt-matrix-keyboard
- msp430单片机，用定时器和IO中断做的矩阵键盘输入，已经经过调试通过-msp430 microcontroller, to do with a timer interrupt and IO matrix keyboard input, has been debugged
msp430-nokia5110-matrixkeyboard-fsk
- msp430驱动矩阵键盘、nokia5110、和fsk调制解调完整工程-msp430 driver matrix keyboard, nokia5110, and complete engineering fsk modem
mcu-fpga
- 单片机与fpga通信，单片机接受，可接受多位数据，该程序为单片机向fpga发送sclk信号，编译已通过-Communicate with the fpga chip microcontroller accepted and acceptable multi-bit data, the program for the microcontroller to send sclk signal fpga
UsbKeyboard
- 给予C51的CY68013A的程序代码，主要内容为模拟键盘功能，实现EP端点传输-CY68013A give the C51 program code, the main contents of simulated keyboard functions, to achieve EP endpoint transfer
traffic-light
- 本代码采用C语言，实现了基于AT89S52单片机的流量控制的智能交通灯系统。-This code implements the flow control intelligent traffic light system.
serial-port
- 一个pc端的串口接收程序，外部只需要单片机串口发送函数就可以实现单片机与pc机的通信-One pc side of the receiver program, requiring only single-chip serial transmission function can achieve single-chip communication with pc
MMA7455
- 基于MDK的开发环境，STM32编写，3.5.0的库，MMA7455程序-MDK-based development environment, STM32 preparation, 3.5.0 libraries, MMA7455 program
RS232-CAN
- RS232转CAN的通讯实例,将电脑RS232输出格式的数据通过单片机接收电路接收后，通过单片机的CAN 驱动模块将数据转发出去。-ROUTINE for RS232 TO CAN
ADS1115_chenshuo
- ads1115的MSP430驱动程序，其中采用了取平均值的算法，很准确-The MSP430 ads1115 driver, which uses algorithms to take the average, and very accurate
DA_KEY
- MSP430F169内部DA的驱动程序，这个程序是为驱动VCA810程控芯片写的驱动，有按键控制等功能。-MSP430F169 internal DA driver, this program is written to drive VCA810 programmable chip driver, a key control functions.
ds1302
- 时钟芯片DS1302的MSP430的驱动程序，模块化书写，很好调用！-DS1302 clock chip MSP430 drivers, modular writing, good call!