资源列表
成品
- 本文件为风力摆控制系统源代码，适用于stm32f103zet6开发板，具体硬件与IO口的连接需要根据自己的机械结构来调整，PID参数也需自行调整，传感器采用MPU9150加速度传感器（陀螺仪）(This document is suitable for stm32f103zet6 development board. The connection between specific hardware and IO port needs to be adjusted according to its
MS5803
- 根据数据手册写的MS5803压力传感器的程序，因为我是看原子的资料学的STM32，所以有他的system文件夹(According to the MS5803 pressure sensor program written in the data handbook, because I'm a STM32 for atomic data, so I have his system folder.)
发动机的电控PID代码
- 小型汽油机控制程序源代码，该代码能实现发动机的喷油与点火控制(Small gasoline engine control program source code)
soduku
- STM32和LCD屏实现的简单数独游戏，适合嵌入式初学者(Simple Sudoku games implemented by STM32 and LCD screens)
单片机的C语言应用程序设计（修订版）
- 很实用的单片机编程资料 案例很详细 可以参考 初学者很不错的资料(Microcontroller Unit contrller system desigen very easy)
单片机
- 51单片机入门，对单片机的基础知识进行总结，共有14个章节。(51 microcontroller entry, the basic knowledge of microcontroller to sum up, a total of 14 chapters.)
工程12864
- 基于AVR的12864显示屏调试程序；SPI通信程序；时序图底层驱动程序；(12864 display debug program based on AVR; SPI communication program; sequence diagram bottom driver;)
RVMDK（uv5）
- 使用红外接收头接收遥控器的按键，通过串口打印键值。(Use the infrared receiver to receive the key of the remote control, and print the key value through the serial port.)
CC2530实验代码教程
- cc2530 的代码及教程 ，内含步进电机程序，RFID射频卡程序、DS18B20温度传感器DHT11温湿度传感器的代码，人体红外传感器代码，MQ-2气体传感器代码等(CC2530 code and tutorials, including stepper motor program, RFID radio frequency card program, DS18B20 temperature sensor DHT11 temperature and humidity sensor code,
FM1702程序
- IC卡读卡加密和读写，51单片机，操作FM1702，注意操作的时候最好禁止中断(IC card reading card encryption and reading and writing, 51 single chip, operation FM1702, attention to the operation of the best prohibition of interruption)
1kg电子秤程序+上限报警设置
- 基于hx711的电子称，量程范围1kg，平台为51单片机(Electronic name based on hx711)
多通道adc
- 对ADC1的通道1、2实现电压采集，并在TFT上显示(Voltage acquisition for ADC1 channels 1 and 2, and displayed on TFT)