资源列表
SPWM_TEST
- 利用msp430f149做的产生SPWM程序，用在逆变电源里面-To produce SPWM using msp430f149 do procedures, used in power inverter inside
AD
- A/D HX711电子称用串口传输程序代码，10Hz或80Hz时钟控制-Codes for the information transportation of Seriors Port with HX711
voltmeter-Vm
- 详细注释的51单片机电压表源程序，Proteus仿真-Detailed annotation of the single 8051 chip microcomputer voltmeter source program, Proteus simulation
LCB-2AB01
- 本系统MCU采用ATmega128，通讯模式为使用SJA1000的PeliCan基本帧模式。 CAN总线比特率：500Kbps（定时器值为0X00 0X16）；PeliCan基本帧模式。总线采用令牌模式控制，上位机掌控令牌权力 -The system MCU ATmega128, communication mode to use SJA1000 PeliCan basic frame mode. CAN bus bit rate: 500Kbps (timer value 0X00
Signal-acquisition
- 8051F350信号采集程序,采集4路模拟信号经过AD转换，成为1路数字信号，由串口发送-Signal acquisition program which was writen by asm language
ds8b20_search_one_ROM
- pic单片机 控制ds18b20 检测id地址-PIC microcontroller control ds18b20 detection id address
STC_LED_drive
- STC12C5A60S2单片机做的LED点阵屏驱动电路原理图。含I2C的EEPROM，和温度传感D18B20。-The circuit schematic of LED display panel driven PCB that using STC12C5A60S2 microcontroller which contains I2C EEPROM and temperature sensor D18B20.
stc_com_232
- stc12c5a60s2单片机串口程序。功能将接收到的数据发送出去。-stc12c5a60s2 microcontroller serial program. It will send the received data.
STC_I2C_232
- STC单片机I2C测试程序。串口测试AT24C02页读写。-The STC MCU I2C test program. The serial test AT24C02 page to read and write.
PWM-Demo
- PIC单片机PWM演示程序，C语言开发，带中文注释，包含头文件和源文件，可以在其他应用中直接包含，可以在初始化函数形参中设置周期和点空比等。带Proteus仿真文件，测试单片机为PIC16F877A-PIC microcontroller PWM demo program, C language development, with Chinese translations, contains header files and source files can be included direct
WH-T-32-2008-DMX512-A
- 很详细的DMX驱动资料，单片机开发或嵌入式开发必备-Very detailed the DMX driver information, microcontroller development, or embedded development necessary
template
- 自动车坐标模块，结合码盘，陀螺仪使用，定位精度一-Automated vehicle coordinate module, combined with the code disc, gyroscope use, the positioning accuracy of a mm