资源列表
LPC1114_SOURSE
- NXP ARM开发参考资料，适合开发初期进行参考-NXP ARM development of reference materials, reference is suitable for early development
Pic18_BootLoader
- Pic18单片机Bootloader源代码-Pic18 MCU Bootloader C Code
enery_chuanlian2
- 针对嵌入式装置中的相关模块电压不同，编写的C程序，将电池电压自动转换控制，实现对装置的远程监控。-According to the voltage of the related modules in the embedded device, the C program is written, the battery voltage is automatically converted to control, and the remote monitoring and control of the
Siren8.19
- 无线警号C代码,解码2262， ASK的 -Wireless Siren Source code
STM32F4_EXTI
- CONTROL EXTI WITH KIT DEVELOP STM32F4
ADC
- CONTROL ADC DAM WITH ARM STM32F4
6pwm
- stc15w4k六路pwm底层程序，一种较为新型的51单片机的底层程序- stc15w4k six-way pwm underlying program, a more low-level microcontroller 51 new programs
SPI
- 该spi通信方式是基于stm32开发板进行编写的，用在芯片scr2100的上面，实现芯片之间的通信方式。-The spi communication is carried out based on written stm32 development board, the chip used in the above scr2100 achieve communication between the chips.
webserver-at91sam9260-ek-iar-
- AT91SAM9260-EK 代码，SDRAM中运行，uIP WEB Server，IAR5.2开发环境-AT91SAM9260-EK codes, SDRAM running, uIP WEB Server, IAR5.2 development environment
USB
- STM32中USB协议例程，具体需要用到PortHelper上位机接受数据-STM32 s USB Protocol，when you need receive the data stm32,you need download a software named PortHelper
Sprinter_Melzi
- 粗红线接HOTEND 白色的接ETEMP 风扇线接FAN，黑色接gnd 以上是喷头的 热床黑色接HOTBED 白色接BTEMP-Thick red wire HOTEND White then ETEMP Fans line connected FAN, black pick gnd These are the nozzle Hot bed of black pick HOTBED White then BTEMP
library
- 脱机打印，首先都是要把gcode文件放到SD卡上，方法一是在电脑的软件里选择SD卡上的文件开始打印，然后就可以拔掉USB线了（当然不拔也可以，随便你。）；方法二是把要打印的gcode文件重新命名成init.g，放在SD卡的根目录下，重新启动打印机（按reset按键或者断电重新上电都可以），机器就自动开始打印init.g这个gcode了。-There are two ways for offline printing, first of all put gcode file on the SD c