资源列表
4PC-sends-string-to-read-MSP430-P
- 使用MSP430F149芯片，透过串口与电脑通信，波特率9600,8数据，无校验。使用32.768k晶振，使用P3.6和P3.7口作为发送和接收口，使用异步通信USART1，采用查询形式。实现通信，当单片机接收到以S结尾时表示命令结束：以WR开始的字符串时，中间的数据最好是二进制的16位，单片机会把中间的数据高八位赋值给P6口，把中间的数据低八位赋值给P4口；以WO开始的字符串时，中间的数据最好是二进制的8位，单片机会把中间的数据赋值给P5口；以RI开始的字符串时，读取P2口P1口的状态，显示到
Signal-acquisition
- 利用红外对管和单片机实现单片机之间的信息传递！-Using Infrared Emitting Diode and transmission of information between the MCU MCU!
ds1302
- ds1302例程，本例程来源网络，本人验证通过，特此上传供大家学习交流-ds1302 routine, the routine source network, I verify hereby uploaded for everyone to learn exchange
TFT
- 本例程源自网络，需配套的硬件进行调试.彩屏配套例程。-The routines from the network, need supporting hardware debug color display supporting routines.
M430G2553PP1602--51
- 本例程源自网络，本人已调试可运行,本例程仅供大家学习交流-The routines from the network, I can run debugging for them to learn the routine exchange
dpjusbxzqd
- 本例程源自网络，本人已调试可运行,本例程仅供大家学习交流-The routines from the network, I can run debugging for them to learn the routine exchange
12-EEPROM
- eeprom例程，调试无误，供大家学习交流，还望高手们提供宝贵意见-eeprom routines, debug and correct for them to learn from the exchange, and also hope the gurus to provide valuable advice
even-numbered-bright
- 间隔300ms先奇数亮再偶数亮，循环三次；一个灯上下循环三次；两个分别从两边往中间流动三次；再从中间往两边流动三次；8个全部闪烁3次；关闭发光管，程序停止-Interval 300ms first odd-numbered bright and then even-numbered bright, cycle three times One Light up and down cycle three times two three from both sides toward the mid
ETK6201
- 厂家没有公布的Datasheet! ETK6201 是1/7～1/8 占空比的 LED 显示控制驱动电路。由 11 根段输出、6 根栅输出、1 根段/ 栅输出，1 个显示存储器、控制电路、键扫描电路组成了一个高可靠性的单片机外围 LED 驱动电路。串行数据通过4 线串行接口输入到 ETK6201 ，采用SOP32 的封装形式。-The manufacturers did not announce the Datasheet! ETK6201 is 1/7 to 1/8 duty cycle LE
sorve_motor
- 使用msp430f2618单片机闭环控制伺服电机工作。为了节约单片机资源，使用了外部计数器。-Use msp430f2618 the microcontroller closed-loop control of servo motor work. In order to save MCU resources, use an external counter.
NRF24L01_receive
- 基于MSP430单片机和NRF24L01的无线接收程序。-Based the MSP430 and NRF24L01 wireless receiving program.
photoelectric_encoder
- 基于MSP430单片机的光电编码器驱动程序。-MSP430 microcontroller-based photoelectric encoder driver.