资源列表
ADXL345MSP430G2553
- ADXL345库函数-MSP430G2553 模拟I2C协议 -ADXL345 Library Function-MSP430G2553, simulation I2C protocol
12864
- 12864库函数MSP430FE427A-The 12864 library function MSP430FE427A
Chip-buzzer-driver
- 单片机驱动蜂鸣器响，给单片机I/O一个低电平驱动蜂鸣器响-MCU drive buzzer to the microcontroller I/O is a low-level drive buzzer
2.7
- 间隔300ms先奇数亮再偶数亮，循环三次； 一个灯上下循环三次； 两个分别从两边往中间流动三次； 再从中间往两边流动三次； 8个全部闪烁3次； 关闭发光管，程序停止。-Interval 300ms first odd-numbered bright and then even-numbered bright, cycle three times One Light up and down cycle three times two from both sides
SHINE-51
- 间隔300ms先奇数亮再偶数亮，循环三次,一个灯上下循环三次-Interval 300ms first odd-numbered bright even-numbered bright, cycle three times, a light up and down cycle three times
shineee
- 间隔300ms先奇数亮再偶数亮，循环三次,一个灯上下循环三次-Interval 300ms first odd-numbered bright even-numbered bright, cycle three times, a light up and down cycle three times
T12864C016-SPI
- T12864C016-SPI.c.LCD驱动-The T12864C016-SPI.c.LCD driver
ATmega32_ili9325
- 基于atmage32写的ov7660摄像头的程序，并将采集到的数据显示在tft彩屏上-The ov7660 camera program based on atmage32 written, and the data collected in tft color screen
MINISTM32-TFTLCD(9325)
- ministm32 开发板的ＬＣＤ显示例子，有一些常用的函数-ministm32 development board LCD display example, there are a number of commonly used functions
1MSP430F149-USART1sends-P1-to-pc
- 程序验证实现，P2口四位控制RS485命令发送格式，P1口有高电平时，接P3.0口的灯一直闪烁，否则不亮，同时发送给电脑显示P1口的状态-Program verification to achieve P2 port four control RS485 command transmission formats, P1 port high, then P3.0 port light has been flashing, and otherwise does not shine, at the s
2MSP430F149USART1sendreceivewithpc
- 使用MSP430F149芯片，透过串口与电脑发送接收通信，波特率9600,8数据，无校验。使用32.768k晶振，使用P3.6和P3.7口作为发送和接收口，使用异步通信USART1，采用中断形式。实现通信，当单片机接收到什么字符后，它会自动把接收的字符发送个电脑-MSP430F149 chip computer through the serial port and send and receive communication baud rate 9600 data, no parity. 32
3PC-sendsdatatoMSP430-P6P5P4
- 使用MSP430F149芯片，透过串口与电脑通信，波特率9600,8数据，无校验。使用32.768k晶振，使用P3.6和P3.7口作为发送和接收口，使用异步通信USART1，采用查询形式。实现通信，当单片机接收到以S结尾时表示命令结束：以WR开始的字符串时，中间的数据最好是二进制的16位，单片机会把中间的数据高八位赋值给P6口，把中间的数据低八位赋值给P4口；以WO开始的字符串时，中间的数据最好是二进制的8位，单片机会把中间的数据赋值给P5口。-MSP430F149 chip through t