资源列表
1.从机
- 无线模块nrf24l01通信程序（包括主机和从机）(Wireless module nrf24l01 communication program (including host and slave))
2.主机
- 无线模块nrf24l01主机通讯程序，基于stm32(Wireless module nrf24l01 host communication program)
基于8086的计算器设计
- 包含基于8086芯片的计算器的程序和其相对应的proteus的仿真图(Calculator program and simulation diagram)
实验一闪烁灯实验
- 单片机闪烁实验，含有实验报告， 并且含有程序，可直接运行(Single chip scintillation experiment, including procedures)
新建 Microsoft Word 文档
- CAN 接收器总共有 5 级接收 FIFO，在接收过程中，收到的报文将会依次在 5 级的输入 FIFO 中进行保存。CAN 中，5 个报文缓冲器在工作过程中通过转换被 交替映射到单片机的每个存储器区域内。RxBG（后台接收缓冲器）只与 MSCAN 相联系，前景接收缓冲器能够通过 CPU 寻址。(The CAN receiver has a total of 5 stages to receive the FIFO, and in the reception process, th
myProject2
- LAUNCHXL-F28027 开发例程(led,key,pwm,sci,epprom Development routine it is good for studying dsp28027)
main
- pdb定时采样ADC，定时采样间隔可修改，(PDB timing sampling ADC)
APDS-9960_RGB_and_Gesture_Sensor-master
- apds9960 android code
frequence test Proteus simulation(C51)
- 通过proteus 仿真 利用51编程实现 频率测量 附有电路仿真图以及所用程序(Through the Proteus simulation, using 51 programming frequency measurement, with circuit simulation diagram and the procedures used)
kgobron_msfm2
- 3rd attempt but i failed again
clock_done
- Digital LED clock 18b20 stc15
67A04 uart
- 原厂对该功能是隐蔽的，如有需要可以参考使用附件的软件，串口对应的IO口为P16和P17(The original factory is covert to this function. If necessary, you can refer to the software that uses the attachment. The serial port corresponding to the IO port is P16 and P17)