资源列表
key_scan
- 单片机驱动剪片扫描C程序，初学者参考例程。-The microcontroller drive clip scan C program reference routines.
LCD
- 液晶显示用C程序，可以作为参考例程，方便初学者阅读练习。-LCD C program can be used as reference routine, easy reading exercises for beginners.
userlcdser_54
- 利用实验箱的模拟信号产生单元产生不同频率的信号，或者产生两个频率的 信号的叠加。在DSP 中采集信号，并且对信号进行频谱分析，滤波等-Experimental box analog signal generating unit generating signals of different frequencies, or to generate a superposition of two frequency signal. Collected in the DSP in the signa
Nokia5510LCD
- 诺基亚5110的资料与程序，程序适用于以下几款单片机：51、MSP430F149、XS128和AVR单片机-Nokia 5110 material and program, and the program is applicable to the following a few SCM: 51, MSP430F149, XS128 and AVR microcontroller
minasuo--mcu51
- 基于51单片机的密码锁设计 四位数码管显示 可以输入三次 三次失败报警 不能输入 不过不是很完善 入门而已-51 MCU-based combination lock designed four digital tube display can enter three times three times fail alarm can not enter, but not very perfect entry.
ex03_Key_LED
- 基于arm，使用按键控制led灯的亮暗-led controled by keybord--arm
huoniu-for_128M(NAND)-FLASH)
- 这是火牛开发板NAND FLASH(128M)+SD卡双U盘的程序，花了一星期时间才调好，绝对可用-This is the AC adapter development board NAND FLASH (128M)+SD double U disk card program, spent a week before a good tune, absolutely available
shizhong
- 简单的电子时钟源码！小巧！方便！可以用于学习QT -Simple electronic clock source! Small! Convenient! Can be used for learning QT
shangladianzu
- 上拉电阻跟下拉电阻的认识，使用刚入门单片机的人看看。-Understanding of the pull-up resistor with pull-down resistor, look at just getting started microcontroller.
chuzhuchejifeiqi
- 出租车计费器外加语音录制和语音播报录音的功能，语音芯片用的是ISD4004-The taxi meter plus voice recording and voice broadcast recording function, voice chip with ISD4004
shizhong
- 用汇编写的基于DS1302的可调时钟程序，采用数码管显示，采用74HC595来串行输出-Written in assembler adjustable clock program based on the DS1302, digital display using the 74HC595 to serial output
dianzhen
- 用汇编写的8.8的点阵小程序，可实现箭头，数字等还几种的变化，采用了Protues仿真。-The 8.8 lattice applet written in assembler can also several changes such as arrows, numbers, to adopt a Protues simulation.