资源列表
test
- 定时器控制蜂鸣器频率，通过定时器0和1分别控制时间和频率来控制蜂鸣器-Timer to control the buzzer frequency by Timer 0 and 1, respectively, to control the time and frequency to control the buzzer
MIDI
- MIDI键盘输出程序 老式键盘改MIDI键盘-MIDI keyboard output program
io_uart
- 在单片机UART缺少的情况下，用IO口模拟UART，占用一个定时器，BAUD可达到9600.-failed to translate
ds18b20lcd
- 多个18b20 单总线挂载驱动程序前提是得自己读出序列号-The premise 18b20 more than a single bus to mount the driver have to read out the serial number
18B20
- 18B20的C语言基础程序，适合初学者使用-18B20 C-language based procedures, suitable for beginners to use
test10
- 这是uc/osii在msp430上移植的详细代码，具有很高的参考应用价值
89C51TEMPERATURE-TEST
- 89C51温度测量测试代码，在开发环境KEIL51上用C语言编写-89C51 MCU temperature test code,wroten by C programing language on KEIL51
wifiadapter2
- wifi接口电路图，工程环境为pads2005-wifi interface circuit, engineering environment pads2005
led8
- AVR使用范例 LED流水灯ATmega16-ATmega16 LED
DAconvert
- YM100实验指导，DA模数转换C语言程序参考。-YM100 experimental instruction, DA ADC C language program for reference.
NXP-LPC9xx
- The BLINKY program is a very simple program that blinks the LED s on connected to Port 2 of the MCB900 or EPM900. When you can successfully build and run this program, you have used the entire toolset including:-The BLINKY program is a very simp
u-boot-1.3.4-exp.5
- u-boot 1.3.4 patch file