资源列表
plotCenter
- 商业应用的切割机输出中心，通过以太网络传输文件，读取PLT图形，及单线体字体-Cutting machine output center for commercial applications, transfer files through Ethernet, read the PLT graphics and single line fonts
ARM93D
- 在ARM9上运行的 3D图形显示程序，很详细的程序设计-3D graphics display program running on ARM9 detailed design procedures
S3Cmini2440
- 基于mini2440通过网络动态预览和控制摄像头的实现-Mini2440 through the realization of dynamic preview and control network camera
mini2440
- 基于mimi2440的开发板，UCOS+CUGUI+触摸屏 的例子-Mimi2440 development board, UCOS+CUGUI+ touch screen-based examples
dsafasfdasfd
- CNC雕刻机（Stm32驱动A3977控制步进电机）实现控制。我这里还有电路图和上位机软件-CNC engraving machine controlled stepper motor) (Stm32 driver A3977 achieve control. I have here the schematic and PC software
HID-Bootloader---labotronik---USBPICBOARD1_0
- Pic18f hid bootloader
HY-STM32examples
- 耀硕HY-STM32开发板MINI 部分例程代码及原理图， STM23F103VZT6,cortex_M3 内核， 基于RVMDK开发平台，V3.0固件库，极易便于新手入门-example codes and schematic of HY-STM32 MINI board， whose MCU is STM23F103VZT6.The codes are bais on RVMDK with V3.0 firmware.
db116.-c
- 1． db116.h源程序：基于单片机控制机的设计的db116.h相同 2.db116. c源程序: -1. db116.h source: the design of the machine based on single-chip control db116.h same 2.db116. c source:
Embedded-tutorial
- 简单的嵌入式教程，能很好的叫你入门!学习嵌入式教程！-Simple embedded tutorials, can be a very good introduction to call you! Learning embedded tutorial!
AD
- DSP代码，c/c++，实现了模数转换功能-DSP code, using c/c++, AD/DA function
KEY
- DSP代码，c/c++，实现了按键的功能-DSP code using c/c++, pressing key and detection function
pwm
- 单片机stc控制程序，PID调节PWM输出-MCU the stc Control program, PID regulator PWM output