资源列表
ucos_on_arm7
- uCOS-II 在ARM7上的移植源代码,我在up-netarm3000已经测试，开发环境是ADS1.2！
基于AVRmega16的智能循迹避障小车源程序
- 全国电子设计大赛作品，语音导航小车代码
cailiaoqingdan
- 超声波测距原理图\硬件资料\cailiaoqingdan.rar-Ultrasonic Ranging schematic \ hardware information \ cailiaoqingdan.rar
SWITH9
- 复合开关，含有AT24C01扩展和单片机串口通信，实现开关状态指示保存和通信-switch
ucos-use-on-51
- 该代码成功将ucos实时操作系统移植到51单片机的硬件平台上，从而让51单片机不再寂寞不再裸跑。-The success of the code will ucos real-time operating system ported to 51 single-chip hardware platform, allowing 51 single-chip is no longer lonely, no longer run naked.
3.interrupt
- 基于lm3s328单片机，采用直接操作寄存器实现中断点亮led.内涵proteus仿真和mdk源码-Based lm3s328 MCU, using direct manipulation of registers for interrupt lit led. Connotations proteus simulation and mdk source
GCC
- GCC_中文手册，对初学者入门嵌入式很重要-GCC_ Chinese manual, very important for beginners
ad_daProgram
- AD—DA转换的程序，很实用，代码已测试OK，可直接使用-AD-DA conversion process, it is practical, the code has been tested OK, can be used directly
CC2500_C
- 很详细的PIC16F877A芯片CC25XX系列驱动程序-A very detailed PIC16F877A chip CC25XX Series driver
28284359ypfx
- 音频信号分析仪,很值得看，与大家共享，与大家一起学习-Audio signal analyzer, is worth a look, and share.
at93c46
- AT93C46/5 5 串行EEPROM 及单片机程序
C_language.tar
- 对想做嵌入式开发的朋友们,这是个很好的资料,里面都是些嵌入式笔试要考的试題-My English is not good!sorry!!