- cpldfpga 《CPLDFPGA嵌入式应用开发技术白金手册》源代码
- speaker 在linux下让PC扬声器发声程序
- RBF rbf神经网络主要用于非线性函数的逼近
- sy2 粒子群算法应用求解一个方程的最优解 Particle swarm optimization for solving an equation of the optimal solution
- Data-FR-v19 file need for simulation of feifei v19
- AY-SEB kit for CCS5.5 例程 msp430f5529官方例程适用于msp430f5529launchpad开发板(The msp430f5529 official routine applies to the msp430f5529launchpad development board)
资源列表
freescale-MPC5634M_FlexCANC
- 飞思卡尔POWER PC CAN控制器驱动-Initialize two FlexCAN modules for 100 kHz bit time based on an 8 MHz crystal. Send a message from FlexCAN A (FlexCAN 0 on MPC56xxB/P/S). The modules will be connected externally in an open drain circuit, before the tran
18B20
- 基于18b20的PIC单片机控制的温度采集-Temperature control based on a 18b20 PIC microcontroller collection
128649
- 128649，不带字库的液晶显示器的驱动，用起来效果非常好。-128,649, non - font LCD driver, together with the effect was very good.
iic
- 51的GPIO模拟iic的驱动程序，用宏来定义硬件管脚，容易移植，keil平台
PowerManage
- PC 2410上实现电源驱动 其他头文件在BIOS中容易找到
CAN
- AT90CAN128 CAN程序代码 程序初始化，数据发送等 -AT90CAN128 CAN程序代码 程序初始化，数据发送等
LCD4BIT
- Header file For LCD 4bit interface with different functions.
sht10inAT89S5x
- 温湿度传感器sht10的51单片机配置程序-Temperature and humidity sensors sht10 SCM configuration program 51
R8C2L_dataflash_WriteaReads-main
- R8C/2L 内部dataflash读写 完整例程-R8C2L dataflash Write&Read program.
CANSF
- 基于CAN总线数据发送与接收,利用sja1000芯片进行数据发送与接收-based on CAN data send and receive
iccard
- 用于LPC系列ARM7CPU上开发CPU/IC卡应用程序-ARM7CPU developed for LPC series CPU/IC card applications
keyboard
- 键盘任务与显示任务联合实验程序，：在实验中，利用五条短消息来完成键盘任务和显示任务之间的通信。程序中用两个按键分别控制数字窗口是否需要显示出来，用两个按键对数字窗口的水平位置进行调整，用10个按键分别输入10个数字，这些数字显示在窗口中。- Keyboard and display tasks experimental procedures, in experiments using five short message communication between the keyboard to