资源列表
flash_op
- DSP操作外部FLASH,包括擦除、单字节读写、块读写-external FLASH DSP operations, including the erasure, single-byte read and write, read and write block
T6963LCD
- DSP的T6963液晶测试程序,数据端口8000H，代码端口8001H
traffic_led(verilog)
- 交通灯verilog源码，在实验板上测试通过-Verilog source of traffic lights, the board tested in experiment
driver
- rensas R8C2K/L在无刷直流永磁电机的换相处理，ABS处理函数。-rensas R8C2K/L in the permanent magnet brushless DC motor commutation process, ABS handler.
DC-motor-controller-and-its-control
- 基于VHDL语言的直流电机控制器及其控制，本控制系统的总体结构,下位机是整个高频疲劳试验机控制器的核心。用于实现产生控制试验机的控制信号和数据，反馈信号的处理，以及和上位机进行数据通信。其控制功能强弱也直接影响着整个控制器性能的好坏-DC Motor Based on VHDL controller and its control, the overall structure of the control system, the next bit machine is the high-freq
DefaultIsr_nonBIOS
- 我做了一块DSP28335的最小系统板，有复位电路、电源电路、JTAG接口、外扩了一片E2ROM、晶振-I made a DSP28335 minimum system board, reset circuit, power circuit, JTAG interface, the external expansion of a E2ROM crystal
long
- 基于51单片机的抢答器的设计，程序简短，具有很高的移植性。-Responder, based on 51 single-chip design, the program is short, and a high degree of portability.
serial-communication-display-by-1602
- 将pc机串口发出来的数据转换成相应的ASCII码值显示在1602显示屏上-Pc serial port issued to the data is converted into the corresponding ASCII code value displayed on the 1602 display on
IOCDrv
- MC9S08MP16 IO采集初始化 LIN 外部时钟源-MC9S08MP16 LIN IO
tlc5620
- 组态王向单片机发送数值（0-5），如发送2.5V，单片机显示2.5，并从模拟量输出通道输出 -Value to the microcontroller sends KingView (0-5), such as sending 2.5V, single-chip display 2.5, and the output from the analog output channels
uart_fifo
- 51单片机串口fifo收发程序，可以用于接收自定义数据帧处理-51 microcontroller serial fifo transceiver procedures, can be used to receive custom data frame processing
c8051f020外围接口电路程序
- c8051f020外围接口包括AD采样，中断，I2C，lcd、数码管显示等程序，适合做最小系统的设计