资源列表
ARM_I2C
- 我编译通过的ARM LPC2210程序段。如有需要，请参考。-I compile the procedures of the LPC2210 ARM. If necessary, please refer to.
xhuankoutongxin
- 利用单片机进行两台电脑之间的通信,可以传递数据和汉字.-SCM between the two computers for communications, data transfer and can be Chinese.
用vhdl语言编写的2进制到10进制转换的程序
- 本文为用vhdl语言编写的2进制到10进制转换的程序，为doc格式，使用前复制于maxplus等相应软件中使用。,This article was prepared by using VHDL language 2 hex to 10 hex conversion procedures for the doc format, the use of pre-replication in maxplus, such as the use of corresponding software.
shiftbetweenserializationandparallel
- 在数据的输入过程中可完成并行数据和串行数据的转换-shiftnbetween berialization and parallel
DS18B20LCD
- C DS18B20测温,LCD显示.cC DS18B20测温,LCD显示.c
Lcd.c
- program to drive a 20X4 or 16X2 lcd. depending on the macro you define .
Uart
- 实现串口驱动设计，非常实用的。主要用在6M16内嵌的SOC上。实现接收发送。-Serial port driver design, very practical. Mainly used in the 6M16 embedded SOC. To achieve to receive the transmission.
PLL210M
- 用VREILOG编写DDS模块 modelsim功能测试通过 十分好用-VREILOG to write the DDS module modelsim function test by the very easy to use
stm32f10x_spi
- stm32f10x_spi串口数据传输，用于无线传输和数据传送-stm32f10x_spi
display
- 89C52单片机控制手机模块tc35i打电话的程序-89C52 MCU control module tc35i phone call program
IDEctrl
- 自编的某项目中的基于NIOS II的硬盘控制程序，支持PIO方式对硬盘的操作-Written and directed a project in NIOS II based on the hard disk control procedures, to support the PIO on the hard disk operation
XIANHAOFASHENG
- 51单片机C语言编制的简易信号发生器，分别产生100hz,75hz,50hz,25hz,10hz,1hz信号，时间间隔为5秒。-Simple signal generator 51 microcontroller C language, and generate 100hz, 75hz, 50hz, 25hz, 10hz, 1hz signal interval is 5 seconds