资源列表
How-To-Setup-on-Raspberry-Pi.txt.tar
- Basic Steps (Detailed below) 1. Install NOOBS. 2. login with ssh. 3. Set the network to static IP Address. 4. Set the hostname to raspbian. 5. Update and upgrade your firmware and software. 6. Increase RAM memory allocation. 7. Insta
AT89C2051andR2RequaltoADC
- AT89C2051和R2R电阻网络构成的模数转换电路ADC，设计成本低-AT89C2051 and R2R resistor network consisting of analog-digital conversion circuits ADC, low-cost design
Linux_V4L_capture
- Linux下通过V4L实现视频采集，使用方法： gcc -o XXXX InitVideo.c 我亲自编写，可以运行，现奉献给大家。-Linux through V4L video collection, use : gcc-o XXXX InitVideo.c I personally prepared, can run, it is dedicated to you.
HG16016002G
- 基于1698的160×160的液晶驱动程序
Oscillograph
- 自己编写的单片机程序，是一个示波器的C语言程序-Their own procedures for the preparation of the single-chip is a C language program oscilloscope
Linux_patch
- Linux下patch的制作和应用（diff与patch工具的使用）-Linux under the patch creation and application (diff and patch tools)
msp430part4
- TI公司的msp430单片机程序，可以参考一下-TI' s MSP430 Singlechip procedures, you can reference. .
128X64_lcd_display
- 液晶显示器12864程序，c语言编写，基于51单片机-12864 LCD process, c language, based on 51 single-chip
caculator_final
- 基于单片机的计算器的设计 基于VisualC++的程序代码-Based on SCM calculator
PortIO
- C8051F系列单品机，IO端口通讯实验，希望对初学者有帮助-the IO port of c8051f
iic
- verilog实现IIC读写AT24C02-IIC rw AT24C02
医院床旁简易呼叫系统
- 假设医院病房有5个床位，每个床头都设有一个按键，当病人按下按键时通过串口将当前床位的按键编码发送至护士站，并点亮代表该床位的 LED。当护士站接收到按键编码后，立即通过串口发送相应的指令编码，关闭当前点亮的代表该床位的LED。 MSP430F5529