资源列表
UARTtoSPI-Synchronous
- Covert SPI to UART STM32 code
gprsdoc
- Gprs无线模块的SDK（商业程序）汇编部分
design
- The verilog implementation of 8-point FFT in verilog. Radix 2 Decimation in Frequency.
bxfsq
- 单片机波形发生器和单片机电机测速装置程序 可发生三角波 正弦波 锯齿波 方波 测速通过红外对管和单片机中断相连进行计数测速-SCM SCM waveform generator and motor speed measurement equipment process can occur sawtooth sine wave square wave triangle wave velocity through the infrared to the microcontroller interru
LCD_DRIVE
- LCD驱动编写小结 LCDR的使用方法 LCD驱动编写小结-LCD驱动编写小结 LCDR的使用方法 LCD驱动编写小结
123445
- 本程序主要通过不断改变视口位置来模仿动画效果，同时介绍了在进行opengl绘图时所做的一些不可或缺的准备工作-This procedure primarily by changing location, as I imitate animation effects, while the introduction during the opengl drawing done some essential preparatory work
SNT-C485
- 抄录符合DL/T645-1997的电表，是用51编写的，大家可以作为参考
I2C
- This I2C project is a simple program for the NXP LPC2900 family microcontroller using the HITEX LPC2929/39 evaluation board and demonstrating I2C functionality using the onboard SE95 temperature sensor.
UART_FIFO_IntRx
- 基于美国群星的LM8962ARM芯片的例程。Usart口-基于美国群星的LM8962ARM芯片的例程。
74HC373
- 用C语言编写的一个关于寄存器74HC373的使用案例，对于单片机的初学者有些用处-The one with the C language on the use of register 74HC373 case of some use for the beginner SCM
45
- 按键扫描与LED灯状态处理流程图，核心为STC51单片机-LED light status button scanning and processing flow chart of microcontroller core STC51
yejingxianshi
- 这是已经显示程序，所用的而液晶是1602，大家可以在上面直接运行，绝对能通过！-This is the procedure has been shown, while the LCD is used in 1602, we can run directly on top, definitely pass!