- hello-world VHDL CODE FOR DISPLAYING " HAPPY WORLD " ON XILINX SPARTAN 3 E FPGA BOARD
- qiyezhan4 网站模板 经典企业网站 静态html asp
- genesis.1.7.1 Genesis Frameword/Template for wordpress. Version 1.7.1
- OFDMA_-transmission-module OFDMA
- arduino_due_lcd1602 arduino deu开发板的1602液晶显示源代码
- tushuchubanguanli 这时一个用c++编写的一个图书出版管理系统
资源列表
tm4_trig
- 德州仪器的tm4单片机通过IIC协议采集温度并通过串口发送-tm4 collecting temperature and sent through the serial port
ARMEthernetTEST
- 嵌入式系统学习 SAMSUNG ARM440BX LAN TEST -SAMSUNG ARM440BX LAN TEST
LED
- LED 数码管显示，PICC PIC16F877A-LED digital display, PICC PIC16F877A
PIRDec
- 红外人员进出感应源代码，开发环境STC11F01，KEIL，可检测人员进出方向-Infrared sensors personnel access to the source code, development environment STC11F01, KEIL, can detect the direction of personnel access
FPC1020+_51Demo
- 应用于FPC1020的51单片机demo，可直接下载使用
ARMU
- ARM读写U盘驱动软件包源程序，有点复杂，但是很多值得大家慢慢学习的，有详细说明和例程。-ARM read U disk drive package source, a bit complicated, but worth a lot of time learning, there are detailed descr iptions and routines.
8051ControlsStepperMotorThroughUART
- 在两块单片机之间，通过串口通信机制，控制步进电机转动和停止。当指拨开关接地时，电机停止；当指拨开关接+5v电源时，电机转动。-Between the two single-chip, through the serial communication mechanisms to control the stepper motor rotates and stops. When the DIP switch is grounded, the motor stops When the DIP swi
PXA270
- 优龙PXA270 开发板的PCB 资料 CORE的一些原理图资料 -PXA270 development board PCB information
timer-clock
- 万年历时钟，用单片机自身定时器，调试为比较精确的定时时间-Timer clock
ds1302+LCD1602
- 这是一个在PROTEUS中进行仿真的LCD显示时钟的程序，利用了DS1302芯片-This is a PROTEUS conducted in the LCD display simulation clock procedures use of the chip DS1302
keyboard-driver
- 单片机键盘驱动资料，包括键盘接口技术介绍、扫描法矩阵键盘驱动程序、行列反转法矩阵键盘驱动程序、AT89S52单片机键盘接口原理图等。程序有详细的注释。资料基于AT89S52单片机系统，键盘为4×4矩阵键盘。-Singlechip keyboard-driven information, including the keyboard interface technology, the scanning matrix keyboard driver, the ranks of matrix inve
uip-0.6
- uIP is a very small implementation of the TCP/IP stack that is written by Adam Dunkels <adam@dunkels.com>. More information can be obtained at the uIP homepage at <http://dunkels.com/adam/uip/>. This is version $Name: uip-0-6 $.