资源列表
shuzishizhong
- 数字时钟程序可以实现24小时的计数用52单片机-Digital Clock program can achieve 24-hour count with 52 single-chip
5
- 12864串口代码，大家可以参考下，有时候串口代码很难找的-12864 serial code, we can refer to, and sometimes hard to find the serial code
485driver
- 经典485驱动程序，非常经典485驱动程序 欢迎使用-Classic 485 driver, very classic 485 drivers are welcome to use
ADC12-Single-channel-conversion-mode
- 430单片机程序之ADC12 单通道转换模式程序。-430 single-chip ADC12 single-channel conversion program procedures.
05_UsingAccelWare
- This lab exercise will introduce you to the AccelWare IP generators. AccelWare is a library of over fifty IP generators, available in the form of three toolkits that produce synthesizable MATLAB for common MATLAB built in and toolbox functions. Each
pcf8563
- 时钟芯片pcf8563控制,时钟芯片pcf8563控制-Contrl pcf8563
can-node-communication
- 该程序已经被多次使用，需要两个sja1000 + 51 + pca82c250的通讯模块（本程序是在P2.6和P2.5设置了LED灯来显示是否通讯成功），将源程序（kaobei.hex）下载到51单片机中，上电后通过按下两个模块的复位键，就能看到对应的模块有指示灯显示-The program has been used many times require two sja1000+ 51+ pca82c250 communication module (the program is set in
sdram_vhdl
- VHDL实现的读取和写入SDRAM的程序代码，学习的人可以参考下-VHDL implementation SDRAM read and write program code, can refer to the following study
RS485
- 基于51单片机的RS232通信+数码管显示程序 可以在数码管上显示串口发过来的数字-51 microcontroller RS232 communication the+ digital tube display program can display the serial port on the digital control sent digital
Grayscale-Conversion-IP
- Sobel Edge Detection IP for FPGA using LABVIEW
BasicFunctionLibrary
- The basic function library for MFRC500 on c1-The basic function library for MFRC500 on c166
nokia5110
- NOKIA5110屏stc15f2k60s2程序-NOKIA5110 screen stc15f2k60s2 program