资源列表
BCD_2_EX3
- BCD码 TO 余3码 转化器 Verilog
trueif
- 一个超前进位加法器（及其testbench) .v文件
winmobpatch
- you can copy and paste into your EVC4 source code It uses #ifdef _WIN32_WCE to make sure the code gets compiled for Pocket PC 2003 project or Smartphone 2003 project. The final executable can then be copied to a Pocket PC 5.0 device or Smar
ALU
- alu 模块，算术逻辑单元，实现简单的控制模块，有最基本的几条指令-alu instruction
test_state
- VHDL code for UART transmission & reception.
VHDLonfir
- FIR滤波器在VHDL中使用(顺序)PROCESS声明或者是加法器和乘法器的“组件 实例”来实现-FIR filter in VHDL use (in order) PROCESS statement or the adder and the multiplier " component instance" to achieve the
LCD
- lcd显示程序，已经调好了得， 直接用，-lcd show keyi
cic5
- 5级级联CIC滤波器的VHDL程序。CIC是最简单最易实现的低通滤波器，通常CIC滤波器如果采用单级，带外衰减不够，因此需要级联使用，5级级联的CIC带外衰减能够满足大多数的设计要求。而带内的衰减可以采用补偿滤波器抵消掉绝大部分。-the code of 5-CIC
msp430x24x_1_vlo
- 脉冲P1.0使用软件的1/100的有效占空比。超低频〜 1.5kHz，超低功耗工作模式表现出来。6 I/ O端口被配置为低电压输出，以消除浮动输入。-Pulse P1.0 with a 1/100 active duty cycle using software. // Ultra-low frequency ~ 1.5kHz, ultra-low power active mode demonstrated. All // the 6 I/O ports are co
lianggehanzizuoyi
- led点阵的向左移动，它可以实现两个汉字的左移，并且能够实现改变汉字的代码从而改变显示的汉字-Moving to the left of LED dot matrix, it can achieve two Chinese characters left shift, and can realize the change of Chinese characters code to change
test
- 用于检测摄像机云台，从而映出四路控制信号，通过单片机控制其他硬件-PTZ camera is used to detect, which reflected the four control signals through the microcontroller to control other hardware
bujindianji
- 用单片机模拟电梯，用步进电机来做电梯的程序。-MCU simulation elevators, elevators do with a stepper motor program.