资源列表
ps2_vhdl
- 利用vhdl实现FPGA芯片从PS2键盘读出数据(0-F) 并在数码管上显示 -use FPGA chip from the PS2 keyboard sensed data (0-F) and displayed on a digital control
led
- 在EPM570开发板上实现LED控制的程序-EPM570 achieve in the development of on-board LED control procedures
tlv5636
- 音频DA tlv5636的接口程序 经过硬件测试的成功 学习状态机对器件编程的经典-DA tlv5636 audio through the interface program to test the success of hardware 。state machine to study the classic programming device
PWM
- This a PWM (pulse-width modulation scheme code in VHDL)-This is a PWM (pulse-width modulation scheme code in VHDL)
clkgen
- 移位寄存器实现分频，避免大量使用分频代码-Frequency shift registers
GG
- 针对DSP实时性的实现，配置与描述，对很好的了解ccs的使用-DSP real-time implementation, configuration descr iption, the use of a good understanding of ccs
1
- 基于vxworks下的ADT860-AT模拟量输出输出控制编程-Control program based on vxworks under ADT860-AT Analog Output Output
jiasu
- 基于多单片机开发，能够实现让步进电机加速的功能-Multi-MCU-based development, a stepper motor acceleration
kalman
- 卡尔曼滤波算法，输入陀螺仪测得的角速度、加速度计测得的角度，输出量为滤波之后的角度，消除零漂。-Kalman filtering algorithm, the input gyroscope angular velocity and acceleration of the measured meter measured Angle, Angle after output for filtering, to eliminate the zero drift.
edge_catch
- 信号去抖动处理程序，通常在时钟沿到来时，信号出现不稳定，这个程序可以处理-signal process jitter
AT89C52
- 用可调电阻调节电压值作为模拟温度的输入量，当温度低于30℃时，发出长嘀报警声和光报警，当温度高于60℃时，发出短嘀报警声和光报警。-Adjustable resistance for adjusting the voltage values as input analog temperature, when the temperature was below 30 ℃, a long beep alarm sound and light alarm, when the temperature i
UART
- 利用C语言写的串口程序，可以利用该程序接收上位机发送的数据-Using C language to write the serial program, you can use the program to receive the data sent by the host computer!!