资源列表
SPITest
- EVC平台上开发的wince程序，实现了使用GPIO模拟spi主机来采集信息。调试SPI时须先低速然后再高速。-EVC for the platform wince procedures, the use of GPIO analog spi host to gather information. When debugging SPI must first low and then high speed.
csbcj
- 基于单片机的超声波测距模块 用汇编语言编写 内有电路原理图-Ultrasonic distance measurement based on single chip module assembly language within the circuit diagram
CANprotol_test
- 针对周立功CAN设备的上位机demo，实现CAN信息定时，统计，等发送功能，可作为调试CAN通讯的上位机软件-Zhou, who CAN devices for PC demo, achieving CAN message timing, statistics, etc. send function, debug CAN communication can be used as the PC software
DS1302
- 51单片机与DS1302时钟芯片对话，读取和写入时间，阳极数码管是通过51单片机控制三极管来驱动的。有原理图。实物我也做过。-51 SCM and DS1302 clock chip, read and write time dialogue, anode digital pipe is through the 51-series microcomputer controlling transistor to drive. Have principle diagram.
display74595
- 也是使用keil软件写的C语言，51单片机控制74HC595芯片驱动数码管。这个方案使用的单片机的引脚少，节省资源，另外74HC595的驱动功能比较大，很合适驱动数码管。-Keil software is used to write c-language, 51 single-chip microcomputer control chip 74HC595 driver digital tube. This scheme using SCM pins less and save resources
GPBR_test
- 本实验实现对RSTC和GPBR的测试，在程序中先往四个备份寄存器里写入相应的值，然后把整个 处理器和外设软件复位 在下次重新启动的时候，在串口里显示四个备份寄存器的值，并和之 前写入的值进行判断，如果相同，那么开发板上的D2灯闪烁，否则D3灯闪烁。 通过串口输出相关信息。-In this study RSTC and GPBR achieve the test in the program before the backup register is written to the fo
clock
- 利用keil软件写的C语言，51单片机控制数码管，内含protues仿真图，这个原理图的实物是已经做出来了。-Using keil software written in C language, 51 single-chip microcomputer control digital tube, containing protues simulation diagram, the schematic diagram of the material is made.
DMA_Test
- DMA测试例程，使用DMA的link list模式进行数据的传输。程序中把源缓冲区SRC1_Buffer和源 缓冲区SRC2_Buffer里面的数据，通过DMA的link list模式分别传输到目标缓冲区DST1_Buffer和 目标缓冲区DST2_Buffer。相应信息可在串口显示。-DMA test routines, the link list using the DMA data transfer mode. Program and the source of the sourc
ADC_test
- 本实验实现对ADC的测试，并通过串口输出相关信息。 本程序运行方式为将程序下载到Internal Flash中运行。-ADC to achieve this study test, and information output through the serial port. Run this program as the program to the Internal Flash to run.
feibiao
- 利用keil软件写的C语言控制51单片机做了一个点灯程序（飞镖），内有protues的仿真文件。-Using keil software write c-language control 51 SCM made a light program (darts), there are protues simulation files.
Blinky
- LPc1768单片机的流水灯使用例程，具有很好的参考价值-LPc1768 single chip using routine light water, a good reference value
max7219
- 使用51单片机控制max7219芯片驱动8位数码管。-Use 51 single-chip microcomputer control max7219 chip drive 8-bit digital tube.