资源列表
correct
- 通过计算出 S1 S2 S3来完成对信息位的查错和纠错并且在每传完512位信息位和384位后检测收到的数据是不是0000,若是0000的话表示接收双方依旧同步 否则将 asyn_flag置为高电平表示不同步-By calculating S1 S2 S3 to complete the information bits and error checking and error correction data received at 512 and 384 after the informa
coder
- 此模块的基本功能是将待调信号与 M序列的每一位进行异或，到达扩频的目的。其中设计了一个5级的移位寄存器用于产生M序列。-The basic function of this module is the signal to be modulated with the M sequence of each XOR reach spreading purposes. Which designed a five shift register used to generate M sequences.
EEPROM_WR
- EEPROM读写器，可以根据MCU的并行数据、地址线和读/写的控制线对EEPROM(AT24C02/4/8/16)的行为模块进行随机的读写操作。-EEPROM reader, can be random read and write operations on EEPROM (AT24C02/4/8/16)
ads129n
- Source code of ADS1292
sport
- 基于FPGA的数字秒表，通过按键开始计时，再次按下暂停，按下复位键清零-FPGA-based digital stopwatch, through the button to start timing, press pause again, press the reset button clears
c
- LCD1602液晶屏显示仿真方波的脉宽时间，可调节脉宽长度，时间也变化-1602 show Fang Bo pulse duration
Cortex-M3-STM32-SDCARD-FAT
- 这是个关天STM32嵌入式系统的SD卡驱动和FAT文件系统读写源代码-This is the write and read source code about STM32 system SD drive and FAT system.
BUJINDIAJI
- 步进电机控制程序，可以实现加速 减速 匀速，里面包含两个程序-Stepper motor control program, you can achieve a uniform acceleration and deceleration, which contains two procedures
ssstm32f4
- STM32F405的参考例程，写的不错，特别是DMA处理方面，很值得学习-STM32F405 reference routines, written in good, especially the DMA processing, it is worth learning
LCD5110
- 基于单片机Mega8的 LCD5110驱动-Based on SCM Mega8 of LCD5110 driver
68360-SMC
- 该程序详尽的描述了68360串口驱动编写，串口每一个寄存器配置，及中断服务函数编写-you can use this program to study 68360
STM32-based-temperature-P-voltage
- STM32温度+电压电流(上位机显示好的)-STM32-based temperature+ voltage display (PC display)