资源列表
LANYATIAOCAN
- 基于蓝牙进行串口调参源码，可直接更改PWM输出参数，基于STM32进行开发，方便对参数进行调整-Based on the bluetooth serial port and source code, can be directly change the PWM output parameters, based on STM32 development, convenient adjust parameters
daolibai
- 在小车上放置摆杆，保持杆子不倒下，实现一个自由度的平衡。内容包括电位器的AD采集，PID算法及PWM配置输出，基于STM32进行运行。-Swinging rod is placed on the car, keep the rod is not down, and realize the balance of a degree of freedom. Potentiometer AD sampling, PID algorithm and PWM output configuration, ba
NRF24L01
- 基于NRF24L01的遥控程序，摇杆AD采集发送，提供发送端和接收端源码。建议收发地址更改掉，避免被干扰。-Based on NRF24L01 remote control procedures, rocker AD collection to send, provide the sender and the receiver source code. Suggest to send and receive address change more, to avoid interference.
BOE3.97_S6D27A2-MCU-16bit)_C8051F-OK
- 基于C8051单片机的驱动，MCU接口16位模式，京东方3.97寸，采用内置驱动IC为S6D27A2，三星的控制器-BOE3.97inch LCD driver IC:S6D27A2 MCU interface 16bit with C8051F,test OK
ADS12_2828__OTM9605_CMI45_540960
- 高清4.5寸屏OTM9605程序,编译工具是ADS12，外置转接芯片SSD2828，内置驱动芯片:OTM9605-ADS12_2828_driver IC:OTM9605_CMI_4.5inch_540960
7inch_LCD_display-LOGO-and-Button
- STM32F103中用7寸屏作显示，显示图标按键，带触摸-7inch_LCD_display LOGO and Button
SPI
- this is an spi example on stm32F4 card discovery
USART
- STM32 F4 UART example:
taxicounter-ATmega16
- AVR类单片机ATmega16与16键键盘和LCD连接应用的设计程序，设计的是简单出租车计价器-single chip of ATmega16
c
- 实现对24C02的操作。一次写入128个数据，写入的地址是128 255.然后通过串口显示出来。-Implementation to the operation of the EEPROM_24C02, a written 128 data, write the address is 128-128. Then displayed via a serial port.
cyclone_ivProgramming-Guide
- 本应用笔记提供了一组简单易用的指南和一列在Cyclone® IV 设计中需要考虑的因素。 Altera 建议在设计过程中遵循本应用笔记中介绍的指南-This application note provides a set of simple and easy to use guidelines and a list of needs to be considered in the Cyclone IV design factors. Altera is recommended t
LM3S1138_ssd1289-spi
- LM3S1138 模拟SPI方式驱动SSD1289液晶屏-LM3S1138 SPI SSD1289 LCD drivers