资源列表
mcu
- MCU在Modbus下位机的程序，实现数据通讯-MCU in Modbus lower computer program，Data communication
MT6070iH-and-MCU-Modubus-RTU
- 威纶工业触摸屏MT6070iH 与单片机Modubus RTU通信协议解析 及相关触屏端和单片机端的程序。触屏端程序用EasyBuilder8000 解压 单片机端程序用Keil打开。 让您的项目中增加更强的用户体验。 -Wei Lun industrial touch screen MT6070iH and Modubus MCU RTU communication protocol analysis and related touch screen client and single pro
barrelshifter
- Here is barrel shifter source code with verilog language
paralleladder
- This a verilog source code for parallel adder-This is a verilog source code for parallel adder
display-program
- 以MSP430F5419为主控，通过串口接收上位机的数据，用数码管进行显示。-Using MSP430F5419 as the main control, through the PC serial port to receive data, digital tube display.
HEAT-meter-program2011-12-16
- 本程序基于MSP430F4152设计，包括对热能表温度，热度，时间差，量程设定，通过串口上传数据给pc机。-MSP430F4152 design based on the program, including the temperature, heat meter heat, time difference, the range setting, upload data to the PC through the serial port.
ADC
- Renesas RX63N ADC control code.
uart
- 通过CPLD，可以进行和电脑的串口通讯。-By CPLD, and computers can be serial communication.
IAR
- 利用单片机控制步进电机的正反转、转速等功能-The use of single-chip stepper motor control reversing, speed and other functions
part1
- LAB 1 - Part 1 DE0 VHDL Tutorial
atmega8pwm
- atmega8 pwm program with scalable frequency
NEw-Project
- #ifndef ANTILIB_GPIO_H #define ANTILIB_GPIO_H #define GPIO_CNF_INPUT_ANALOG 0 #define GPIO_CNF_INPUT_FLOATING 1 #define GPIO_CNF_INPUT_PULLUPDOWN 2 #define GPIO_CNF_OUTPUT_PUSHPULL 0 #define GPIO_CNF_OUTPUT_OPENDRAIN 1 #de