资源列表
ADCP
- STM32F407discovery上的ADC程序-STM32F407discovery on the ADC program
NAT9914-dirver
- nt9914 驱动, 比较简单，GPIB控制器开发可参考-nt9914 drive, relatively simple, GPIB controller development may refer to
hongwai
- 基于msp430的1838T红外接收串口显示程序，可将红外遥控器32位遥控器识别码和键码以十六进制显示-Based on the msp430 1838T infrared receiver serial display program can be infrared remote control 32 remote control ID and the key code in hexadecimal
SPI_DMA
- 针对STM32意法半导体中的spi通信模块，采用DMA方式-For the STMicroelectronics STM32 spi communication module, using DMA mode
51-keyboard-scan-code
- 这个是51单片机最简单的键盘扫描程序 注：键盘连接P1口 输出按键为 GetKey-This is the easiest 51 single keyboard scanner NOTE: P1 port output to connect the keyboard keys to GetKey
TL19-CURRENT-TEST-E(ZZ)
- 目标板电流测试(对外接负载的电流进行检测，并且可通过串口读取)-CURRENT TEST
ATmega32_tft_ov7670_REV4.2
- ATMEGA32操作摄像头并用TFT显示屏显示。摄像传感器是OV7670-ATMEGA32 operate the camera with TFT display. OV7670 image sensor is
zs
- 基于fpga的数字频率计，verilog编写，可修改闸门宽度0.1s/1s/10s，可测频率1hz~1mhz，包含整个工程，内部分频模块为了仿真方便改小了，后面注释为50mhz晶振下的分频值，可根据需要自行修改-Fpga-based digital frequency meter, verilog prepared to modify the gate width 0.1s/1s/10s, measurable frequency 1hz ~ 1mhz, contains the entire
MCU_DSP
- 单片机十大软件滤波算法程序，单片机进行DSP操作。-Ten SCM filtering algorithm software program, microcontroller DSP operations.
seg7
- fpga上nios处理器avalon总线数码管驱动，包含任务逻辑，寄存器，和接口的verilog HDL描述-fpga nios processor avalon bus on digital tube driver, including the task logic, registers, and interfaces verilog HDL descr iption
SCM_MODULE
- 字节写的一些atmega128单片机程序模块，编译环境是ICCAVR。包括uart0、1602（四线操作和八线操作）、ds1322、ds18b20、内部adc、内部E2PROM和延时函数模块等。-Byte write some atmega128 microcontroller program modules, the compiler environment is ICCAVR. Including uart0, 1602 (four-wire operation and eight-wire
PWM-car
- 小车PWM运行，能够控制小车车速，还能前后左右的控制-Trolley PWM operation, able to control the car speed, but also around the control