资源列表
SC_CPU
- single cycle CPU element design with Verilog
SCMr-control-stepping-moto1
- 单片机 汇编程序 控制步进电机 复杂动作如正反转-Microcontroller assembler control stepper motor complex actions such as reversing
DigitalDesignofSignalProcessing
- This chapter begins from the assertion that the advent of VLSI (very large scale integration) has enabled solutions to intractable engineering problems.
pivotal-game-driver-code
- 基于Verilog的贪食蛇游戏驱动代码及算法分析-Verilog-based pivotal game driver code and algorithm analysis
led
- STM32 ，点亮LED灯，针对IAR编译环境-STM32, lit LED lights for the IAR compiler environment
s3c24a0_usbmon_0614
- 三星s3c24a0开发板的USB驱动程序，可以用来测试和参考。-Samsung S3C24A0 development board USB driver can be used to test and reference.
KF903-M104C-C51
- C51单片机通过I2C接口控制M104C的操作例程-C51 microcontroller through the I2C interface control M104C operation routines
WinCE_M104BPC
- 在WINCE平台，通过串口控制M104的操作例程-WINCE platform, through the serial port control M104 manipulation routines
driver
- STM32单片机通过SPI接口控制ST7565R液晶的代码-STM32 MCU through the SPI interface control ST7565R LCD code
1_lab1
- （1）熟悉S6 CARD实验板； （2）熟悉ISE集成开发环境； （3）3比特加法器仿真与上板实验； （4）m序列产生器仿真与在板Chipscope调试 -(1) be familiar with the S6 CARD experimental board (2) be familiar with ISE Integrated Development Environment (3) 3-bit adder simulation experiment on board (4
pianoend
- 用8×8点阵显示“1 2 3 4 5 6 7”七个音符构成的电子琴键盘。其中点阵的第一列用一个LED点亮表示音符“1”，第二列用二个LED点亮表示音符“2”，依此类推-88 dot matrix display " 1 2 3 4 5 6 7" of seven notes of the piano' s keyboard. The first column of the lattice with a LED lit notes, " 1" , notes
CHECK
- 本迷宫小汽车选用8位STC90C52单片机为控制器，通过3个红外光电传感器E18-D80nk对信号进行采集，采集到的信号经串口转换MAX232CPE处理后传给STC90C52单片机，经单片机处理后，发出控制命令给L298N，驱动2台直流电动机进行相应的动作。该小车实现了前进、后退、左右转弯、避障以及显示运行时间等基本功能，整个系统结构简单，可靠性高，实验测试结果满足要求-STC90C52 microcontroller pass the maze of car use 8 STC90C52 si