资源列表
LCD-1602-Module
- 液晶1602模块 使用KeilUv2开发，汇编程序-Liquid crystal 1602 the module use KeilUv2 development, assembler
LCD-Counter
- 液晶计数器 0~9999,使用KeilUV2开发环境，汇编程序-LCD counter 0 to 9999
LCD-electronic-clock
- 液晶电子钟 AT89S51,开发使用KeilUV4-LCD electronic clock AT89S51, developed using the KeilUV4 of
UpUARTData
- DM648DSP中，基于DSP/BIOS建立的网络线程上传串口数据的端口。-DM648DSP in the establishment of the network based on the DSP/BIOS the threads Upload serial data port.
yejing
- 本程序是液晶显示程序，用单片机来实现液晶的驱动，可以做液晶实验-This program is a liquid crystal display program, LCD driver MCU LCD experiment can do
aaa
- 这是一个单片机流水灯程序，用AVR单片机实现，很简单-This is a single light water program with AVR microcontroller is very simple
UCOS
- 51单片机UCOS系统移植，包括全部源码，以及自己写的部分代码，编译通过-The 51 single-chip UCOS system transplantation, to including the the the all source code, as well as to write their own of the part of the code, the compiler through
smgdingshi
- 本程序是数码管定时显示程序，可以做电子钟来使用-This program is a digital tube the timing display program, can do electronic clock
shumaguan
- 用定时器计时，数码管从1到100显示，希望给大家的参考-Timing, digital tube with a timer from 1-100 hope for everyone' s reference
gpio-i2c1-debug.tar
- 海思Hi3515通过GPIO口来控制电机的方式实现云台控制-Hass Hi3515 way to control the motor via the GPIO port PTZ control is accomplished. .
daojishi100s
- 本程序是用AVR单片机做100s倒数计时用的，希望跟初学这个参考-This procedure is used the AVR do 100s countdown with the hope that with the beginner this reference
MotorStepper-aHI3507-board
- HI3507 IPCAM 云台控制程序代码。主要使用单片机STC11L08XE控制电机驱动实现云台控制，通过串口实现与CPU通信。-The HI3507 IPCAM PTZ control code. Mainly use the microcontroller STC11L08XE control motor drive PTZ control, communication through the serial port to achieve with the CPU.