资源列表
QPY_0808_TEST
- PY系列8为接口8位色屏，使用STC11L60XE单片机驱动，外部晶振12M. 驱动电压5V，编译环境：keil uvision4 该函数主要实现：单点/8点清屏、读写显存、亮度调节、写边框、填充色块、写数字、刷新显示等测试-PY Series 8 interface 8-bit color screen, use STC11L60XE microcontroller drive, an external crystal 12M. Driving voltage of 5V, t
M2300PUSB_HID_TEST
- stm32f103c8t6 usb口通讯例程-stm32f103c8t6 usb通讯
ad
- 利用AD0809多路采集系统单片机Proteus仿真-Take advantage of the the AD0809 multichannel gathering system microcontroller Proteus simulation
STC89C52_Soft-reset
- STC89C52RC单片机软件复位例程。用数码管显示。-STC89C52RC SCM software reset routine. Digital tube display.
STC89C52_idle-mode
- STC89C52RC单片机空闲模式例程，1S累加并显示到数码管上，第6秒进入空闲模式，外部中断0可让它继续运行。-STC89C52RC microcontroller idle mode routine, 1S accumulated and displayed on the digital tube six seconds into the idle mode, external interrupt 0 allow it to continue to run.
UART2
- STM8 单片机UART2头文件：串口收发基本程序-The the STM8 microcontroller UART2 header file: serial transceiver program
digital-power-c-program
- 基于ATMEGA16A 的 DCDC直流电源-The based ATMEGA16A DCDC DC power supply
CAN-Loopback
- can 测试实验(中断回环模式) USART1 测试信息通过USART1在超级终端中打印出来 -can test the experiment (interrupt loopback mode) the USART1 test information by USART1 HyperTerminal print out
signal-generator-
- 信号发生器 关键词：ATmega16、LCD12864、ICC AVR、AVR Studio、Proteus、AD5310、UA741、SPI 用ATmega16单片机控制AD5310产生正弦波、方波、锯齿波、三角波信号。通过按键可以切换信号类型、改变信号幅度和频率。 -Signal generator Keywords: ATmega16, LCD12864 ICC AVR, AVR Studio Proteus, AD5310, UA741, SPI, ATmega16
005KMGONG
- 一个基于STC12C2052XX 看门狗功能测试程序，调试通过，可方便网友对STC的参考学习。-Based STC12C2052XX watchdog function test program debugging through the convenience of users of the STC reference learning.
VIIC_C51
- 按照协议规定，总线空闲时两线为高，当进行通信时，SDA在SCL高电平时由高变低表示通信开始（ void iic_start(void) ），以后传输数据，SDA只能在SCL为低的时候才能发生变化，在SCL上升抓取数据；而停止位是在SCL高时SDA由低变高（void iic_stop(void) ）。-Under the agreement, the two-wire bus is idle is high and when to communicate, SDA SCL high, from h
C8051F330Pch452
- C8051F330+CH452的应用实例。-Application examples of C8051F330+CH452.