资源列表
display
- 在hotel单片机下接受外部信号，通过中断判断是否有键按下-good
yingyong
- 12864液晶显示,并行数据传送，液晶采用并行连接-AT89S52+LCDD12864
temperaturepickup
- 使用汇编编写的，采用达拉斯的温度传感器ds18b20 ，注意时序的要求，采用串行通信-Written in Assembly, with Dallas temperature sensor ds18b20, pay attention to timing requirements, using serial communication
protus
- (1) 实现两片单片机之间的串行通信，一片完成发送功能，一片完成接受功能； (2) 发送端在发送数据之前要求对数据进行简单的编码，接收端在接收数据之后需要对所接收的数据进行解码； (3) 用Protus软件进行仿真，要求界面清晰，能够直接看出功能。 -(1) to achieve two serial communication between the microcontroller, a complete send function, a complete acceptance f
lwjjwl
- 实现步进电机的正反转控制，并且能够调节步进电机的转速-Step Motor Reversible control and can adjust the speed of stepper motor
lwj2
- 通过51单片机在工业生产中实现顺序控制，故障的判断-Through 51 in order to achieve industrial production control, failure of the judge
kongwen
- 一个arm7的控温程序。里面带有proteus的仿真电路。仿真CPU负载很高。-A arm7 temperature control procedures. Inside the simulation with proteus circuit. Simulation CPU load is high.
danpianjiCjiaocheng
- 原名：单片机C语言程序设计。本书详尽的介绍单片机C语言编程的开发，希望对大家有所帮助-Original name: microcontroller C programming language. This book describes in detail the development of SCM C language programming, I hope to be helpful
danpianji
- 对单片机原理进行了介绍，主要是接口的说明以及应用-Of the SCM principle was mainly a descr iption of application interfaces
TMC428
- AVR单片机控制TMC428步进电机控制芯片驱动步进电机运转-AVR Microcontroller control TMC428 stepper motor driver to drive stepper motor control chip operation
microcontrollermotorcontrol
- AT89S52产生PWM直流电机调速 键控 加减速-PWM DC Motor Speed Keying acceleration and deceleration
Proteus-hongwai_led
- Proteus单片机仿真实例大全里面的红外遥控部分和LCD、LED部分， 全部设计都有原代码的-Proteus Daquan inside MCU simulation of infrared remote control and LCD, LED part of the design has all the original code