资源列表
DA
- DA转换实验，微机接口实验，汇编语言，实验报告。-DA conversion experiments, computer interface experiment, assembly language, laboratory reports.
AD
- AD转换实验，微机接口实验报告，汇编语言-AD conversion experiments, lab reports microcomputer interface, assembly language
I2C
- I2C通讯实验，微机接口实验报告，汇编语言-I2C communication experiment, lab report microcomputer interface, assembly language
Desktop
- dspic33f AD采样dma功能，求得4路电压有效值，实际项目应用文件 -dspic33f AD sampling dma functions, obtained 4 rms voltage, actual project application files
DA
- 使用D/A转换器生成一个梯形波和一个方波-Using the D/A converter to generate a trapezoidal wave and a square wave
Desktop
- 电力仪表测量电压，电流，有功，无功，等电力参数，用PIC和ATT7026 数码显示-Electricity meters measure voltage, current, active power, reactive power, and other electrical parameters, with the PIC and ATT7026 digital display
sht11
- atmega8和sht11温湿度传感器通过protues仿真并通过串口终端显示代码。工具：winavr-atmega8 and sht11 protues simulation temperature and humidity sensor through and through serial terminal display code. Tools: winavr
proteus
- proteus元器件对应表，最好用最全面的一个。-Proteus components corresponding to the table, the best use of one of the most comprehensive
avrbootloader
- Iar环境下avr_bootloader的编写，可以参考参考。-Preparation of Iar under the environment of avr_bootloader, can refer to the reference.
MSP430-control-TLV5613
- 这个是用MSP430单片机驱动12bit并口数模转换器TLV5613的例子程序。程序中sent_data = 0x0fff，输出模拟电压为最*值。-This is done using the parallel port MSP430 microcontroller driver 12bit DAC TLV5613 example program. Program sent_data = 0x0fff, the analog output voltage to the maximum ref
M1
- 连接在无极性的二总线上，用于监控压力开关等输出开关量信号的设备。-Promise of the two connected on the bus for monitoring pressure switch output switch signal equipment.
M2
- 实时监控并接收主机发出的控制命令，启动相应的设备。-Real-time monitoring and control commands issued by the receiving host, start the appropriate equipment.