资源列表
19264E-01
- 利用51单片机来对19264液晶进行点阵的扫描，隔行闪烁，然后换行扫描-Used on 19 264 51 MCU to be dot-matrix liquid crystal scan, interlaced flicker, and then wrap scan
LCDmima
- 密码锁程序，有lcd显示，带键盘输入，经过测试-Lock procedures, lcd display with keyboard input
DS18B20
- 使用DS12C887，DS18B20，1602液晶做的一个温度和时钟的显示应用系统，可设定报时，设定的报时时间存放在AT24C02中-Use DS12C887, DS18B20, 1602 to do a liquid crystal temperature and clock display applications, can be set timekeeping, set timekeeping time stored in the AT24C02
fengmingqi
- 同时用两个定时器控制蜂鸣器发声， 定时器0控制频率，定时器1控制同个 频率持续的时间，间隔2s依次输出 1，10，50,100，200,400,800, 1k（hz）的方波? 设晶振频率为12MHz。-At the same time the buzzer sound with two timers, Timer 0 control the frequency of Timer 1 control with a frequency, duration, interval 2s
LEDdongtaixianshi
- 利用动态扫描方法在六位数码管上显示出稳定的654321. 时钟频率为11.0592M-Dynamic scan of the six digital control on the show stable 654 321. Clock frequency 11.0592M
can-node-communication
- 该程序已经被多次使用，需要两个sja1000 + 51 + pca82c250的通讯模块（本程序是在P2.6和P2.5设置了LED灯来显示是否通讯成功），将源程序（kaobei.hex）下载到51单片机中，上电后通过按下两个模块的复位键，就能看到对应的模块有指示灯显示-The program has been used many times require two sja1000+ 51+ pca82c250 communication module (the program is set in
nRF401_test
- nfr401测试源码，主要在是无线模块在51单片机上的测试源码-nfr401 test source, mainly in the 51 single-chip wireless module on the test source
direc_motor(done)
- 直流电机驱动，在lpc2000些列开发板上的-DC motor drive, the more out lpc2000 development board
bujin(done)
- 步进电机驱动，开发板lpc2000系列上的-Stepper motor driver, development board lpc2000 series on
assp_motor
- NEC电子电机控制ASSP芯片MMC-1的驱动，其中包括1138板子下的，lpc2000系列下的，和ucosii系统下（也是1138板子上的）-NEC electronic motor control ASSP chip MMC-1 drivers, including 1138 under the board, lpc2000 series under, and ucosii systems (which is also on the 1138 board)
Car_Demo
- 基于凌阳61板智能声控小车代码，下载到单片机训练成功后即可使用-Sunplus based intelligent voice-activated car plate code 61
duoluwendujiance
- 多路温度检测系统，实现温度的多点测量，并显示-Multi-temperature detection system, to achieve multi-point temperature measurement and display