资源列表
ST7-BLDC
- ST BLDC控制算法源码,基于ST7单片机，比较实用-ST BLDC motor control lib
NRF905(51)
- NRF905无线传输 单片机程序 1为发送 2为接收-NRF905 wireless transmission program a microcontroller to send two to receive
nxpMClib_v1.0_0
- NXP 电机控制源代码库，最新版本，有参考价值-NXP motor contorl lib
CRC
- 在进行串口通讯时需用到的CRC，这里详细说明CRC算法的步骤同技巧-Required when performing serial communications to the CRC, the CRC algorithm described here in detail the steps the same skills
Desktop
- 单片机晶振为11.0592MHz的纳秒级别延迟子函数 迷宫小车，五个传感器，三个控制转弯-Microcontroller crystal is 11.0592MHz nanosecond-level latency Functions Labyrinth car, five sensors, three control turning
Desktop
- 简单舵机循迹小车，无岔路口出现，四个传感器控制转弯大小-Simple servo tracking car, no fork in the road appears, turn four sensors control the size of
xunji
- 简单直流电机循迹代码，无岔路口情况，五个传感器控制-Simple DC motor tracking code, no fork in the road situation, five sensor control
test-program
- 51单片机测试直流电机和步进电机的测试程序，包括直流电机正转、反转、调速、定时正反转和综合测试程序，步进电机的正转两相四拍、正转两相八拍，反向两相四拍、反转两相八拍，两相四拍两相八拍调速和步进电机综合程序。-51 single test DC motors and stepper motor test procedures, including DC motor forward, reverse, speed, time reversing and comprehensive test prog
24c02
- 每次开机,开机数值加1并存储到24c02-Incremented by 1 each boot boot and stored 24c02
24c02-iic
- 用按键加减操作一个数字，数字变化后写入24c02，当关机重新再开机，调用上次最后使用的数值这种方式用于存储用户的自用数据和上次使用状态-Key subtraction operation with a number written after the digital change 24c02, re-boot when off, call the last number used in this way is used to store the value of the user s own d
song
- 8个按键控制8个音符 定时器 数码管动态扫描-8 keys to control 8 notes Timer Digital tube dynamic scan
tuoji
- 舵机进行循环左右摇臂动作 20ms周期，高电平时间从0.5ms~2.5ms,最大范围，根据不同舵机调整-Cyclic servo arm movements around 20ms cycle, high time from 0.5ms ~ 2.5ms, maximum range, depending on the steering adjustment