资源列表
GLCD
- stm32f103zet6的3.5’LCD TFT显示屏驱动程序，显示驱动IC为SSD1963。程序中内有画线、画方框、显示字符等功能。-stm32f103zet6 of 3.5 ' LCD TFT display driver, display driver IC for the SSD1963. Program within the line drawing, painting boxes, display characters and other functions.
EEPROM
- STM32F103ZET6的I2C程序，外设读写AT24C01A器件。程序中有字节读写，随机读写和块读写功能。-STM32F103ZET6 the I2C procedures, read and write AT24C01A peripheral devices. Procedures are byte read and write, random read and write and block read and write capabilities.
UsbDisk
- 圈圈usb 硬盘 实现源码，用c编写，kile编译通过-usb c
qiaoqiaoban
- 这是电子设计大赛的跷跷板程序 是培训写的代码 实验通过迅速找点-This is electronic design contest of seesaw program is written code training experiment through find something quickly
sdio_fatfs
- 利用stm32采用文件系统读写sd卡。因为项目，所以去掉了LFN功能。-Using stm32 and fatfs, reading and writing from sd card
motor
- 基于MSP430的，步进电机驱动程序。 内外比例为1:64-MSP430-based, stepper motor driver. Ratio of 1:64 and outside
lcd1602
- 基于MSP430的LCD1602的驱动程序。能够直接显示字符串，数值等形式-MSP430-based LCD1602 driver. Able to directly display the string, numeric and other forms
EEPROM-clock
- 实验名称：电子时钟 利用EEPROM进行存储 实验现象：断电复电继续显示 -Experiment name: Electronic clock using the EEPROM to store experimental phenomena: power restoration continues to show
1302clock
- 实验名称：数码管显示时钟演示程序 程序说明：利用1302做成的电子钟-Experiment name: digital display clock demo program Program Descr iption: 1302 made use of the electronic bell
StepMoto
- 这是使用stm32f100r8t6 开发的二相四线步进电机的驱动程序。 使用方法：（1）想要调用InitStepMotor()初始化端口等 （2）然后调用StartStepMotor() 设置步进电机方向和步数 （3）最后频率性的调用StepMotorGo()即可，当然此频率就是步进电机的频率。-This is done using stm32f100r8t6 developed two-phase four-wire stepper motor driver. How to use
StepA3966
- 这是用allegro 3966芯片来驱动两相四线步进电机的电路模块， 原理图和PCB都有，不用修改直接打板就可以，保证可用！-This is allegro 3966 chip to drive the two-phase four-wire stepper motor circuit module, schematics and PCB have, without modification can directly play board to ensure that available!
PWM_Test
- MC9S12DP512单片机的PWM模块初始化及产生编程-MC9S12DP512 MCU PWM module initialization and produce programming