资源列表
EX03_RTC
- EASY5509 RTC 实验 则可看输出窗口输出时间信息。-EASY5509 RTC experiment output window you can see the output time information.
51-Frequency-meter
- 51单片机做的频率计演示程序,数码管显示,外部中断取样,抛砖引玉,举一反三.-51 single-chip frequency counter demonstration program, the digital display, the external interrupt sampling, appetizers, replicability.
EX04_EXINT
- EASY5509 外部中断实验 单击一下开发板上的S2按键，会触发一次INT0中断，同时会打印输出信息："EXINT ouccers" -EASY5509 external interrupt experimental development board S2 click of buttons, triggers a INT0 interrupt, and it will print out the information: " EXINT ouccers"
PWM-tiaoguang
- 利用定时器产生PWM，LED灯由亮到灭，由灭到亮逐步变化，也就是调光现象-Use of timers generate PWM, LED lights from bright to off, off to light by a gradual change, which is dimming phenomenon
DHT20
- 51单片机做的DHT20温湿度测试程序,6位数码管显示,可以直观的观察到温湿度变化.-51 single-chip DHT20 temperature and humidity testing procedures, six digital tube display, you can visually observed to temperature and humidity changes.
chuankoutongxin
- 打开串口调试程序，将波特率设置为9600，无奇偶校验 晶振11.0592MHz，发送和接收使用的格式相同，如都使用 字符型格式，在发送框输入 hello，I Love MCU ，在接 收框中同样可以看到相同字符，说明设置和通信正确-Open the serial debugger, set the baud rate to 9600, no parity crystal 11.0592MHz, send and receive using the same format, su
AD_DA_PCF8591
- IIC协议PCF8591ADDA转换 读取电位器的电压，并输出模拟量，用LED亮度渐变指示-IIC protocol PCF8591ADDA conversion, read potentiometer voltage, and outputs analog, with LED brightness gradient directions
zhengfanzhuan
- 本程序用于测试4相步进电机常规驱动，非常好用-This procedure is used to test conventional drive 4-phase stepper motor, very easy to use
yinyuebofang
- 定时器控制 定时播放优美音乐。包含定时器中断函数、音乐处理函数。-Timer control timing play beautiful music. Contains the timer interrupt function, music processing functions.
rtxPc51
- rtx+c51.c 源码rtx+c51.c -rtx+c51.c Code
LCD35
- 不错的拓普微3.5寸LCD显示屏驱动代码，可以参考-Good TOPWAY 3.5-inch LCD display driver code, you can refer to it
Ttiny13
- ICCAVR环境，LED电筒代码，带电池低电提示.-ICCAVR environment, LED flashlight code, with a low battery prompt.