资源列表
rftxrx
- CC2500的C51完整工程(包括发送和接收代码)-CC2500 TX RX Demo Code
TouchPad153_ver_A3
- AM8EB153 SOP-8 触摸按键程序-AM8EB153 SOP-8 Touch Key Demo Code
ILI9341_code
- 驱动芯片为ILI9341，控制器LPC2220，总线方式，数据宽度16位-Driver chip ILI9341, controller LPC2220, bus mode, data width 16，3.2TFT
bsc
- AVR用于构建基于USB的GPIB控制器-Program acts as a system GPIB controller using USB
chengxu
- 有关飞思卡尔的2015年摄像头组的例程的一部分-Freescale routine
upd7210-2.1
- NEC公司GPIB控制芯片uPD7210的驱动程序-uPD7210 driver
LED
- 一种基于C，实现超大屏幕LED的控制方案-Control scheme based on C, realization of large screen LED
MOTOCONTROL
- 一个基于c，附硬件四脚高低电平输入对应输出接图，实现电机自动控制的程序- A high and low legs corresponding to the input output interface Figure based c, attached hardware, to achieve automatic control
Robot
- 一个基于C，实现红外遥控自动巡边自动机器人的程序-Based on C, infrared remote control to achieve automatic automatic robot program Inspected
dance-microcontroller-
- 一个基于c，74LS595驱动的单片机开发舞蹈机器人的程序-Based on c, 74LS595-driven robot dance microcontroller development program
Crane
- 一个C，单片机实现自动吊装吊车功能的程序-A C, SCM automatic lifting crane function procedures
20-5_servo1
- 舵机调试程序,C8051F040,舵机控制信号管脚,为P0.7管脚,系统时钟为24500KHZ/8=3062.5KHZ,周期为20ms，则频率为50HZ，则tmph+tmpl=61250可以保证产生50HZ PWM.-Steering debugger, C8051F040, servo control signal pins for the P0.7 pin, the system clock is 24500KHZ/8 = 3062.5KHZ, a period of 20ms, the f