资源列表
89C51PWMhuibianyuyan
- 利用汇编语言对C51单片机进行PWM的输出控制。-C51 microcontroller output to the PWM control using the assembly language.
jiaotongdeng
- 利用51单片机编程实现交通灯的功能，以红绿黄三灯的转换来显示路口状态。-Programming microcontroller 51 using the traffic light function to convert red, green and yellow lights to show the status of the intersection.
NE555
- 利用NE555芯片设计实现一个脉冲发生器。并且利用动态数码管显示脉冲的频率。-Implemented using a pulse generator NE555 chip design. And using the frequency dynamic digital display pulses.
L298N_drive-module
- L298N电机驱动模块，包含L298N的详细资料和操作程序。-L298N motor drive module, including L298N details and operating procedures.
PWM
- 脉宽调制PWM在小车中的应用，包含介绍文档，和相应代码。-Pulse width modulation PWM in the car in the application, including the introduction of documents, and the corresponding code.
YEJINGPING
- 有关c51单片机的keli和proteus的液晶屏的c语言编写和仿真模型的搭建- U6709 u5173 u5355 u7247 u7287 u7684 u7684 u642D u5AR
spi_lcd5110-
- STM32的NOKIA 5110液晶程序，带了DMA哦，强烈推荐，我改了多次，2017年最新上传，PUDN独一无二。-STM32 NOKIA5110
Ultrasonic--ranging
- 超好的超声波测距程序，，能实现测距，我这个程序花了一周才写出来，分享给大家-Ultra high precisionultrasonic ranging program
atmeag8-battery-capacity-test
- 基于ATM eag8设计的电池容量测试仪,软件为C语言,硬件为AD格式.-Based on the ATM eag8 design of the battery capacity tester, the software for the C language, the hardware for the AD format.
keil
- 一、单片机点亮8个发光二极管实验 1）P1口外接8个共阴极发光二极管，点亮高4位； 2）p0口接8个共阳极发光二极管，点亮高4位； 3）P0口接8个共阴极发光二极管，点亮高4位；-A single chip lit 8 light-emitting diode experiment 1 (P1) 8 common cathode light-emitting diodes, light up to a high of 4 2) P0 port to con
keil
- 单片机点亮数码管实验（不能用定时器功能） P0口接1个八段式共阴极LED数码管，通过调用延时子程序，循环显示0-9，时间间隔自定，注意使用一维数组给出显示代码-MCU lit digital tube experiment (can not use the timer function) P0 port connected to the 1 paragraph of the common cathode LED digital tube, by calling the delay sub
keil
- 3）P0口接2个八段式共阴极LED数码管，片选信号分别接P1.0，P1.1，让两个数码管显示数字57；-3) P0 port 2 eight segment common cathode LED digital tube, chip signal are respectively connected with the P1.0, P1.1, two digital tube display digital 57