资源列表
led
- 利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"，并保持-Dynamic scan and Timer 1 in the digital pipe shows start from 765 432 to 1
3_3
- 同时用两个定时器控制蜂鸣器发声， 定时器0控制频率，定时器1控制同个 频率持续的时间，间隔2s依次输出 1，10，50,100，200,400,800, 1k（hz）的方波。设晶振频率为12MHz。-At the same time the buzzer sound with two timers, Timer 0 control the frequency of Timer 1 control with a frequency, duration, interval 2s tu
2_7
- 间隔300ms先奇数亮再偶数亮， 循环三次；一个灯上下循环三次； 两个分别从两边往中间流动三次； 再从中间往两边流动三次；8个全部闪烁3次； 关闭发光管，程序停止。-Interval of 300ms the first odd and then even bright light, cycle three times a light cycle up and down three times two separate flow from both sides to the
Servo_PID
- This code shows application PID algorithm for steering of the servo. Microcontroller ATmega16, servo TG9e and 2 range finders Sharp GP2Y0A21YK. Under indications of 2 range finders the corner between range finders and a surface is defined. Then on th
bujindianji
- 基于单片机的步进电机的控制，实现对步进电机的简单控制-Microcontroller-based stepper motor control of stepper motor' s simple control
spi
- 基于单片机的通过spi控制语音芯片，实现录音、播放等功能-Spi-based Microcontroller controlled by voice chip, to achieve recording, playback and other functions
51
- 基于51单片机 12864的液晶测试程序-12864 液晶程序
BTF040
- 完成C8051F040单片机常用功能，便于开发者开发，缩短开发时间。-It give the source file to the developer for developing .
nrf2401
- C5081F310控制实现NRF2401实现发送与接收-C5081F310 control NRF2401 to relize recieve and send
h
- WiMAX Throughput Evaluation of Conventional Relaying Pavel Mach1, Robert Bestak1 1 Department of Telecommunications Engineering, Faculty of Electrical Engineering, Czech Technical University, Technicka 2, 166 27 Prague 6, Czech Republic {
dipin
- 用atemega128单片机测比较低的频率-Microcontroller with atemega128 low frequency measurement
PWM
- 用atemag128单片机产生的占空比为0.25的pwm方波-Microcontroller with atemag128 generated pwm duty cycle square wave 0.25