资源列表
duoubleserial
- atmel公司AT89S52模拟双串口在数据采集上的应用-ATMEL Corporation AT89S52 simulated dual serial data acquisition in the application
C51LCDdisplay
- C51驱动LCD显示器的单片机程序。可以显示英文，数字-C51-driven LCD monitor SCM procedures. It shows in English, figures
Bank_EX1
- SCAN.C(338): warning C280: UpLoadReady : unreferenced label-SCAN.C (338) : warning C280 type : UpLoadReady : unreferenced label
voltage_source
- 一个毕业论文<数控恒压源> 其中有电路图及电路板,还有kell c源程序. 建议大家做相关课题的看看.-a dissertation
P.H.Y_programer
- 单片机的程序集.大家可以参考一下.我想做一个更好的程序集及电路板.大约在10月份完成.请有兴趣的关注一下.当然我还要做一个通信的vhdl的仿真.-SCM suite. We can take a look. I would like to do a better procedures for collecting and circuit boards. About October completion. those interested in the look. of course, I sti
89ROBOT
- 采用CAN总线设计机器人的分散式机器人控制系统，CAN 总线程序，上位机程序-using CAN bus design robots scattered robot control system, CAN procedures, procedures for PC
ds1502
- 时钟芯片1302的读写， -1302 clock chip reader, the 1302 clock chip reader,
Zardoz_ASM_ST2202
- Sitronix电子词典ST2202芯片的Zardoz汇编程序。-Sitronix electronic dictionary Zardoz ST2202 chip assembler.
16bsWeb
- 一种基于16位单片机的tcp/ip协议源码-based on the 16-bit MCU tcp / ip-source agreement
ds1991_12Mhz
- 门禁读写程序代码，在12Mhz下，已经营机通过仿真器测试通过 -seldom read and write code, the 12Mhz, has been operating pass through the simulator test
can_apply
- 在学习CAN应用设计中的一点心得体会，也算是走了一些弯路，现在把它写出来和大家共 同交流。 -learning CAN Application Design a bit of experience, it was nonetheless taken some detours. and now everyone says Su Shih-sharing.
bus_i2c
- 这个程序是对12c器件读写的使用程序代码，里面有可以在仿真器上运行的代码，如果想用的话，可以去掉前面的代码，在自己定义一下寄存器变量即可。-12c to use the device to read and write code, inside the simulator can run on the code, if you want to use it, then we can remove the previous code, in their own definition of what