资源列表
3-FM-1-SOUND
- PIC18F4520点亮蜂鸣器发响程序,适合初学者-PIC18F4520 FAM PROGRAMER
F5529_W5500_yeelink_V1.0
- 基于MSP430F5529的W5500与yeelink网站通过以太网通信-MSP430F5529 W5500 and yeelink based web site through Ethernet communication
dds-parallel-control
- 此为AD9850芯片的并行控制程序，此程序可以产生单频信号，输出能够达到40MHZ，具体视电路状态决定-This is the the AD9850 chip parallel control program, this program can generate a single-frequency signal, the output can be achieved 40MHZ, depending on the state of the circuit decision
1602-diplaydriver
- 1602液晶显示驱动.内含完整代码,已测试通过-1602 Display Driver,include all code
dianzizhong
- 单片机电子钟程序，单片机电子钟程序单片机电子钟程序-MCU clock program, microcontroller MCU clock electronic clock program procedures
GSM.PDU
- GSM的短信收发模块，还可以得，我是学这个的新手，有不对之处，还需要多多指教。
2
- c51语言编写24秒篮球比赛倒计时，串口输出用数码管静态显示。-c51 language basketball game 24 seconds countdown, serial digital output with a static display.
Timer-interrupt-for-task-switching
- 定时中断实现任务切换,CPU 在空闲任务循环等待，定时中断将 CPU 周期性唤回，根据任务设计了不同的响应频度，满足条件的任务将获得CPU资源，CPU为不同任务“关照”完成后，再次返回空闲任务，如此周而复始，对于各个任务而言，好像各自拥有一个独立的CPU，各自独立运行。用这种思想构建的程序框架，最大的好处是任务很容易裁剪，系统能够做得很复杂。本程序就用了这种思想，使不同的灯用不同的频率闪烁。 -Timer interrupt for task switching, CPU cycles wa
flash_W25Q64BV
- 本代码是通过I/O口模拟SPI总线，再在这个基础上实现W25Q64BV这款flash的驱动。基于MSP430F149这款单片机。-This code use the I/O port to simulate SPI bus, and then base on this module to achieve W25Q64BV flash drive. The microcontroller is MSP430F149.
ADC2
- adc2,模拟数组转换程序，可用，已做实验验证-adc2, Analog the array conversion program, available
ceshilaiguan
- 自己编的测试微触开关程序，可用于限位，测量行程。基于AVR16单片机，编译环境ICC.-Own micro-touch switch of the testing procedures, can be used to limit, surveying trip. Based on the AVR16 microcontroller, the compiler environment ICC.
mywork
- 此程序通过MSP430控制四相步进电机实现爬行车的移动，同时可通过红外遥控对单片机下达命令。-This program contorl four-phase stepper motor of crawling cars moving through MSP430, while the microcontroller gets orders through the infrared remote control.