资源列表
spi
- STC89C58软件实现SPI口做主机,STC12C4052的SPI口设为从机.实现双CPU通信.由主机从SPI口发送0x55,从机SPI口接收到数据后+10=0x5f,从SPI口发送回主机.主机接收后发到串口.串口助手观察接收数据．程度通过keil c51调试并下载到ＳＴＣ晶片运行．
SeeSawTrolley
- 跷跷板小车，，2007年的全国大学生竞赛题，，控制类题目，，今年要参赛的朋友可以看看哦，，使用单片机ATmega128-Seesaw car, the 2007 national college title race, and control type of topic, the entries this year, a friend to see Oh, the use of single-chip ATmega128. .
dianzizhong
- 能显示时 分 秒,误差不超过2秒/小时,时分秒能够分别通过按键进行设置,也可有定时提醒功能-electron clock
CheckSpeed
- 用单片机设计的测速表源程序，测量转速，使用霍尔传感器，被测轴安装有12只磁钢，即转轴每转一周，产生12个脉冲，要求将转速值（转/分）显示在数码管上。-Speed table with a single chip design source, measurement speed, use the Hall sensor, measured shaft equipped with 12 magnets, which turns a shaft to produce 12 pulses, reques
2012-06-05_-
- 非常好用的好用的时钟器，可以记录时间，年月日等，-Very easy to use and easy to use a clock that can record the time, date,
STC-analog-serial
- STC-模拟串口STC-analog serial-STC-analog serial
ADC0809
- 基于单片机的AD转换程序，并用数码管进行显示，可以将单片机的数字信号转换为模拟信号-Based on SCM AD conversion program, and digital pipe that can be of single chip will digital signal into analog signals
DS1302
- DS1302的驱动程序，如有个别地方不太规范，请自己修改。-DS1302 driver, if individual areas are not the norms, to make changes.
46R23ad_tes
- HT46R23 + 24C02.输入信号最大5V,最大显示 1023 . AD 转换起步有16mV死区,其余非常准确和稳定.- HT46R23+ 24C02. Input signal maximum 5V, the greatest show 1023. AD conversion has started dead-16mV, and the rest is very accurate and stable.
05070
- 被动红外传感器开关，自动感应人的存在开关电器（如路灯等设备）程序处理传感器采集的信号并滤波后执行相应动作
Road-ADC-STC12C4052AD
- Road ADC STC12C4052AD - 1 - a serial port monitoring-Road ADC STC12C4052AD- 1- a serial port monitoring
lcd12864
- 12864显示程序 12864显示程序-12864 display program