资源列表
Freq_Gen1
- c8051f020的时钟频率设置，这个很重要，使用好该单片机的前提-c8051f020 clock frequency settings, this is very important to good use the premise of the SCM
Infrare_TRX_CodDecod
- 红外发射,接收编解码 // Target : M16 // Crystal: 8.0000Mhz-Infrared transmitter and receiver codec// Target: M16// Crystal: 8.0000Mhz
7LEDShow
- 4位数码管动态显示1234,8951C51源程序-4-bit digital tube dynamic display 1234,8951 C51 source
c8051
- 直流电机控制 主要是单片机控制直流电机的运转 -DC motor controls for the operation of microprocessor controlled DC motor
CTC
- 单片机的定时器在CTC模式下的测试部分的程序-SCM CTC timer mode, the test in part of the program
ds18b20
- stc单片机的关于ds18b20的驱动程序，需要的稍微改下就好了-stc microcontroller driver on ds18b20, needed a little change like the following
sed1520
- sed1520 控制的12232液晶程序-sed1520 LCD control program 12232
TEA5767forC51
- TEA5767收音机模块的C51控制程序-TEA5767 radio module of the C51 control procedures
LCD_m16
- LCD Library for Atmega
Road_Test
- 采用状态机实现的装考的C语言程序源码，非常全面，经验证，效果不错，欢迎评论-Installed using the state machine implementation of the C language test program source code, very comprehensive, proven, well, welcome to comment
car-tianzige
- 在小车前端安装4对光电对管做传感器，在地上用黑胶带贴出田字格，小车就能按照预先设定转弯，前进，停止。本文用的是AT89S52单片机-Front-end installed in the car 4 on the photoelectric sensor on the tube to do, put tape on the ground with black swastika grid, the car will be able to turn in accordance with pre-set
bujindianji
- 电机反转正传的源代码,对于初学者具有很好的借鉴意义.代码描述了用单片机控制步进电机的方法.-The True Story of the source code of the motor reverse, for beginners with a good reference. Code describes stepper motor control using SCM methods.