资源列表
GATA.rar
- 51单片机GATA位测量脉宽，可以放心使用,GATA-bit pulse width measurement of 51 MCU, you can rest assured that use. .
IIC
- 本例程为I2C协议通讯代码，基于单片机开发，具有很好稳定性。-This routine communication code for the I2C protocol, based on single chip development, with good stability.
HC595
- 4个移位锁存器HC595驱动，带锁存和输出使能-4 HC595-driven shift latch with latch and output enable
HoleNoTest
- 计算炮孔编号,解析万位，千位，百位，十位和个位的数字，便于8位单片机处理-Calculate Hole number
1
- 利用单片机定时器0实现脉冲计数，通过tl0查询巧妙地去除按键的抖动-The use of single-chip Timer 0 for Pulse count, by cleverly removing key tl0 check the jitter
sun
- 函数计算日出日落时间，只需调用函数即可，输入经纬度计算-Function to calculate sunrise and sunset time, you can simply call the function, enter the latitude and longitude calculations
guo-ling
- 利用MCS-51单片机的定时中断，实现PWM控制电机的转速小到大，大到小，急停。本程序通过测试通过！-Use of MCS-51 microcontroller timer interrupt, the PWM control of the motor speed, large to small, emergency stop. The program by pass the test!
ADc
- 通过按键控制不同波特率上传ADC轮换结果，配合天翔老师的PL51开发板使用。-Different Baud Rate Upload ADC rotation results.
bujinmada-
- 实现步进电机的运转，可以完成步进电机的快进和减速-Stepper motor operation, you can complete the fast-forward and deceleration of the stepper motor
Practical-timer
- 同时用两个定时器控制蜂鸣器发声，定时器0控制频率，定时器1控制同个频率持续的时间，间隔3s依次输出1，10，50,100，200,400,800,1k（hz）的方波。 为了保证定时的准确性 晶振选择12M-The same time with two buzzer timer control, timer 0 control frequency, Timer 1 control with a frequency of duration, interval 3s sequentially outp
main
- 对于单片机初学者而言不错的练习程序，2.4寸彩屏显示-this is useful for beginner
test4
- PIC16F1847 program,display,interrupt