资源列表
1dinsizeLCD
- 一款车载自动伸缩显示屏的C51 代码， 使用MYSON C58 MCU ， 具有管理时钟，电机，配电，遥控接收等子程序-A vehicle automatic retractable screen C51 code, the use of MYSON C58 MCU, clock management, electrical, power distribution, remote control receiver, such as subroutine
3.5InchPM
- 一个3.5寸工业控制板子的扩展接口的设计资料，包括电路图和PCB 图。-A 3.5-inch expansion of industrial control board design data interface, including the circuit diagram and PCB.
TEST09
- 高速存储器SST25V08的读写。 通过ISP口（4线）。 单片机为ATXMEGA128A1。-SST25V08 reading and writing high-speed memory. Through the ISP I (4 lines). Singlechip ATXMEGA128A1.
key
- 单片机按键去抖动，不同于书上解释的延时去抖，程序比较有启发意义-Single-chip key to jitter, the interpretation is different from the book go to stir up delay, the more instructive
voltmeter
- 利用 8051 制作出 電壓表, 最高電壓為 15V-using 8051 to make a voltmeter, max voltage is 15V
LCD_Interrupt
- LPC2478 LCD显示中断控制例程，接3.5寸TFT LCD，565RGB模式-LPC2478 LCD display control routine interrupted, and then 3.5-inch TFT LCD, 565RGB mode
LCD_cursor_interrupt
- LPC2478 硬件游标中断例程。TFT 3.5寸LCD。565RGB 模式-Cursor LPC2478 hardware interrupt routines. TFT 3.5-inch LCD. 565RGB mode
USART_128L_090611
- atmega128L 两个USART：USART0和USART1的应用程序，多机通信模式暂缺-atmega128L USART0 and USART1 Multi-devices communication mode is needed
Dem
- 学习用定时/计数器产生PWM波。实现对直流电机转速的检测和开环控制-Learning to use timer/counter PWM wave generated. DC motor speed to achieve the detection and open-loop control
sy
- 利用ADC0809和DAC0832实现模拟电压信号的采集与输出。-ADC0809 and DAC0832 to use for analog voltage signal acquisition and output.
Demo
- 使用T1作为定时器（定时时间为50毫秒），T0作为计数器（计数由电机测速电路产生的脉冲个数，每转4个脉冲），每1秒时间后，读出T0的值（读出后须将T0清0），将该值（速度值*4）显示到LED数码显示器上-The use of T1 as a timer (time of 50 ms from time to time), T0 as a counter (counting from the electrical pulse generated by gun circuit number, 4 p
music
- 基于51单片机的音乐例程，单片机C语言轻松入门-51 single-chip-based music routines, single-chip C language easy entry