资源列表
51timer
- 51下定时器做1秒精确延时，可直接用作模块调用-Under 51 to do 1 second precision timer delay can be directly used as a module called
628
- 飞思卡尔智能车调试程序，有关舵机和直流电机的PID控制算法-Freescale debugger smart car, the steering gear and the DC motor PID control algorithm
TCPIP
- 基于51单片机，在此基础上裁剪TCP IP程序-based on 51microcontroller,TCP/IP programm is writeen
OK20070907
- 可测范围:0-125度 DS18B20的信号脚接P1.7 -asm
51
- mcs51常用的十进制运算子程序，下载即用-asm
menu
- 用lpc2368设计菜单，无操作系统，菜单采用消息机制进行处理，分成三个函数实现-Design lpc2368 menu with no operating system, menu mechanism to deal with the use of information, grouped into three function
my12864
- 通用的12864液晶显示程序，该程序适用于图形液晶显示任何图案字符，并在任意位置显示。-12864 LCD common procedures, the procedures apply to any design graphics liquid crystal display characters, and in any location.
ex4-5
- 外部中断INT0，使用AT89S51的P1连接到8颗LED，P1在正常状况下会输出跑马灯，然后通过用户触动外部的硬件来中断INT0，当INT0引脚有低电位的脉冲出现时，8个LED会一闪一灭。-External Interrupt INT0, use AT89S51 of P1 is connected to 8 LED, P1 will be in normal circumstances the output Marquee, and then through the user to touc
ex4-4
- 计时器Timer0的溢出中断控制：使用8051的P1连接到一个共阳七段显示器，然后利用计时计器Timer1，让8051在指定的时间间隔内显示出0~9。-Timer0 overflow interrupt timer control: the use of 8051 a total of P1 is connected to a Seven-Segment Display Yang, and then use time keiki Timer1, so that in 8051 within th
ex4-3
- 七段显示器的控制，使用8051的Port1连接到一个共阳的七段显示器，然后让8051轮流显示0~9。-Seven-Segment Display control, the use of 8051 a total of Port1 is connected to the city' s Seven-Segment Display, and then rotate so that 8051 showed 0 ~ 9.
ex4-2
- 指拨开关的输入，本代码的目的是使用8051的Prot1连接到8颗LED，Prot2则连接到1个指拨开关，当用户拨动开关时，相对应的LED就会亮或者灭。-Dial switch input means, the purpose of this code is to use 8051 to connect to the Prot1 of 8 LED, Prot2 is a means to connect to the dial switch, when a user DIP switch, the
ex4-1
- LED的控制，应用AT89S51芯片的P1口输出跑马灯，使得LED0，1，2，3，4，5，6，7依次闪烁-LED control, application AT89S51 chip output port P1 of the Marquee, the LED0, 1,2,3,4,5,6,7 followed by scintillation