资源列表
bu
- 51单片机的步进机小程序。单片机具体型号为：STC89C52-51 single-chip stepper machine applet. MCU specific model: STC89C52
8253testingcode
- 测试8255芯片的好坏-test 8255good or bad
Intoduction-to-the-PIC
- Introduction to PIC Microcontroller
SD2300
- 时钟芯片SD2300 C语言驱动程序，在KELL下调试通过-Clock chip SD2300 C language driver debugging through the KELL
ADC_MCP3302
- 模数转换芯片MCP3302 C 语言驱动程序，在KELL 上编译通过-Analog to digital conversion chip MCP3302 C language driver, compiled by the KELL
ADC_MCP3301
- 模数转换芯片MCP3301 驱动程序，用KELL编译通过-Analog to digital conversion chip MCP3301 driver, compiled by using KELL
ADC0832
- 一个模数转换器ADC0832 C语言驱动程序，在KELL 上调试通过-An ADC ADC0832 C language driver debug via the KELL
24lc02b
- 一个完整的24C02B EEPROM C语言驱动程序，用KELL编译通过-A complete 24C02B EEPROM C language driver, compiled by using KELL
RF-PIC16F689
- 一个完整产品的遥控芯片HCS301原程序，利用PIC16F737来进行处理，用MPLAB IDE V7.31+PICC编译通过，目前已经成熟-A complete product of the original remote control chip HCS301 program, to be processed using PIC16F737 with MPLAB IDE V7.31 PICC compiler, is now ripe
IIC-AT24C02
- 基于STC89C52单片机，自己编写的EEPROM驱动程序，软件模拟IIC读取。-Based on STC89C52, the EEPROM write their own drivers, software simulation IIC read.
smg-clock
- 基于STC89C52,自己编写的数码管显示时钟的程序，八个数码管显示为：XX-XX-XX，系统有四个按键，功能分别是调整，加，减，确定。在按下调整键时候，显示时的两位数码管以1Hz频率闪烁。如果再次按下调整键，则分开始闪烁，时恢复正常显示，依次循环，直到按下确定键，恢复正常的显示。-Based on STC89C52, write your own digital display clock program, eight digital display is: XX-XX-XX, the sys
TLV5638
- AVR单片ATmega32\ATmega16\ATmega8\ATmega128的TLV5638驱动程序,ICCAVR7.2开发环境-the driver of TLV5638 base on ATmega32\ATmega16\ATmega8\ATmega128，the develop environment is ICCAVR 7.2