资源列表
spi
- 基于单片机的通过spi控制语音芯片，实现录音、播放等功能-Spi-based Microcontroller controlled by voice chip, to achieve recording, playback and other functions
bujindianji
- 基于单片机的步进电机的控制，实现对步进电机的简单控制-Microcontroller-based stepper motor control of stepper motor' s simple control
Servo_PID
- This code shows application PID algorithm for steering of the servo. Microcontroller ATmega16, servo TG9e and 2 range finders Sharp GP2Y0A21YK. Under indications of 2 range finders the corner between range finders and a surface is defined. Then on th
2_7
- 间隔300ms先奇数亮再偶数亮， 循环三次；一个灯上下循环三次； 两个分别从两边往中间流动三次； 再从中间往两边流动三次；8个全部闪烁3次； 关闭发光管，程序停止。-Interval of 300ms the first odd and then even bright light, cycle three times a light cycle up and down three times two separate flow from both sides to the
3_3
- 同时用两个定时器控制蜂鸣器发声， 定时器0控制频率，定时器1控制同个 频率持续的时间，间隔2s依次输出 1，10，50,100，200,400,800, 1k（hz）的方波。设晶振频率为12MHz。-At the same time the buzzer sound with two timers, Timer 0 control the frequency of Timer 1 control with a frequency, duration, interval 2s tu
led
- 利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"，并保持-Dynamic scan and Timer 1 in the digital pipe shows start from 765 432 to 1
RTC035A01
- RTC035A01彩色液晶模组采用51单片机（MCU）控制的方法-RTC035A01 TFT LCD With MCU interface GOOD DISPLAY
crc
- 这是CRC16的代码，有需要的朋友可以看看啊，。是VB6.0的代码-This is the CRC16 code, there is need of a friend can see, ah. Is the VB6.0 code
impfse
- this helps us to understand and enhance the knowledge on fractionally spaced equalizer of constant modulus algorithm
imp
- This paper helps to present the knowledge on the wimax and we can enhance the knowledge on wimax
im
- this paper deals with the knowledge about the performance of the blind equalizers using wimax and this wimax is also mobile wimax which accepts different frequencies. This is also called as flexible wimax
lpc11xx.cmsis
- NXP LPC11xx (Arm Cortex-M0) library-NXP LPC11xx library