资源列表
MIPI
- 新型图像传感器的传输协议！
led
- LED显示功能，使用VHDL语言编程，基于FPGA-LED display, the use of VHDL language programming, based on FPGA
jtd1
- 交通灯实现的源程序，可实现简单的交通灯控制，用七段数码管显示时间-The realization of the source of traffic lights, can be a simple traffic light control, with Seven-Segment LED Display Time
enable_and_comb1
- 3G通信中的CPRI协议用VHDL语言来实现的。-the implement of CPRI of Communication Protocol
I2C
- I2C通信协议的C语言形式，可以使用这个用来和读写EEPROM-I2C communication protocol C-language form, you can use this to read and write EEPROM
servo_PWM
- 舵机控制程序，采用VHDL编写，测试成功可同时控制多个舵机-Servo control procedures, the use of VHDL to write, test can simultaneously control multiple servo success
Traffic_lights
- 用VerilogHDL编程，在QuartusII软件仿真下实现交通灯的简单程序。-With VerilogHDL programming, software simulation in QuartusII traffic lights to achieve a simple procedure.
vhdl_cnt_16
- 可预置16位计数器 可预置16位计数器-vhdl_16bit_counter
TKC7524jiekoudianluchengxu
- 根据TLC7524输出控制时序，利用接口电路图，通过改变输出数据，设计一个正弦波发生器。TLC7524是8位的D/A转换器，转换周期为 ，所以锯齿波型数据有256个点构成，每个点的数据长度为8位。.FPGA的系统时钟为 ，通过对其进行5分频处理，得到频率为 的正弦波-TLC7524 output under the control of timing, the use of interface circuit, by changing the output data, the design o
SAMP_RATE
- this VHDL program can count and measure a time of high-level of a signal by a high-frequency refrence signal.
boxingfashengqi
- 波形发生器一种数据信号发生器，在调试硬件时，常常需要加入一些信号，以观察电路工作是否正常-A data signal generator, waveform generator, in the debugging of hardware, it is often necessary to add some signal to observe the circuit is working properly
FFTr4
- 基4的FFT运算程序，快速傅里叶变换，并且优化-FFT using TI s optimized FFT function and real-time input